User manual SONY CFD-31

[. . . ] -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/ TV technician for help. This class B digital device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. [. . . ] · The CD-R/CD-RW was not finalized. Finalize the CD-R/CD-RW with the recording device. · There is a problem with the quality of the CDR/CD-RW, recording device or application software. · Replace all the batteries with new ones if they are weak. CAUTION The use of optical instruments with this product will increase eye hazard. On placement · Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. · Do not place the player on an inclined or unstable place. · Do not place anything within 10 mm of the side of the cabinet. The ventilation holes must be unobstructed for the player to operate properly and prolong the life of its components. · If the player is left in a car parked in the sun, be sure to choose a location in the car where the player will not be subjected to the direct rays of the sun. · Since a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or spring-wound watches away from the player to prevent possible damage from the magnet. · Do not use solvents such as benzine, thinner, commercially available cleaners or anti-static spray intended for vinyl LPs. · Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be a considerable rise in temperature inside the car. · Do not stick paper or sticker on the CD, nor scratch the surface of the CD. Before you replace the batteries, be sure to take out the CD from the player. · To use the player on batteries, disconnect the AC power cord from the player. · When you operate the player on batteries, you cannot turn on the player using the remote. 2 to a wall outlet On operation · If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lenses inside the CD player section. Should this occur, the player will not operate properly. In this case, remove the CD and wait about an hour for the moisture to evaporate. · If the player has not been used for a long time, set it in the playback mode to warm it up for a few minutes before inserting a cassette. · Reorient the player itself to improve AM reception. Sony R20P: approx. 20 h Tape playback The audio is weak or has poor quality. · Replace all the batteries with new ones if they are weak. · Move the player away from the TV. Sony R20P: approx. 15 h CD playback Preparing the remote C Insert two size AAA (R03) batteries (not supplied). The picture of your TV becomes unstable. · If you are listening to an FM program near the TV with an indoor antenna, move the player away from the TV. Sony R20P: approx. 414 × 164 × 257 mm (w/h/d) (16 3/8 × 6 1/2 × 10 1/8 inches) (incl. batteries) Supplied accessory AC power cord (1) Remote control (1) Design and specifications are subject to change without notice. Replacing battery With normal use, the batteries should last for about six months. [. . . ] Then proceed as follows: To repeat a single track repeat all tracks shuffle play repeat tracks in random order program play Then do this Press the number button for the track you want to repeat. "PGM" Press the number buttons for the tracks you want to program in the order you want up to 20 tracks (see fig. Press the number buttons for the tracks you want to program in the order you want up to 20 tracks. Select "REP 1" To adjust the volume Press VOLUME +, ­ (VOL +, ­ on the remote). Playing a tape 1 Press TAPE (direct power-on). [. . . ]