User manual SONY CFD-580

[. . . ] For customers in Canada To prevent electric shock, match wide blade of plug to wide slot, fully insert. 2 Introduction CFD-580. E_3-858-521-6X. CA2 Table of contents Basic Operations Basic Operations 4 6 8 Playing a CD Listening to the radio Playing a tape 10 Recording on a tape The CD Player 12 Using the display 13 Locating a specific point in a track 14 Playing tracks repeatedly (Repeat Play) 15 Creating your own program (Program Play) Setting Up 22 Choosing the power sources 23 Selecting the audio emphasis (Sound Mode/MEGA BASS) EN Additional Information 24 26 28 29 30 Precautions Troubleshooting Maintenance Specifications Index The Radio 16 Presetting radio stations 17 Playing preset radio stations The Timer 18 Setting the clock 19 Waking up to music 21 Falling asleep to music Introduction 3 CFD-580. E_3-858-521-6X. CA2 Basic Operations Playing a CD 3 1, 2 Connect the supplied AC power cord (see page 22). 1 Press OPEN/CLOSE down to open the CD compartment and place the CD on the CD compartment. With the label side up 2 Close the lid of the CD compartment. 3 Press ^ (direct power on). The player plays all the tracks once. Display Track number Playing time 4 Basic Operations CFD-580. E_3-858-521-6X. CA2 Use these buttons for additional operations POWER OPEN/CLOSE Basic Operations VOLUME +/­ + p ^ = Tip Next time you want to listen to a CD, just press ^. The player turns on automatically and starts playing the CD. To Adjust the volume Stop playback Pause playback Press VOLUME +/­ p ^ Press again to resume play after pause. + = OPEN/CLOSE POWER Go to the next track Go back to the previous track Remove the CD Turn on/off the player Basic Operations 5 CFD-580. E_3-858-521-6X. CA2 Listening to the radio 12 Connect the supplied AC power cord (see page 22). 1 Press BAND until the band you want appears in the display (direct power-on). Display 2 Hold down TUNING/TIME SET +/­ until the frequency digits begin to change in the display. [. . . ] Press PRESET +/­ to tune in a stored station. The Radio 17 CFD-580. E_3-858-521-6X. CA2 The Timer Setting the clock DISPLAY/ENTER TUNING/TIME SET +/­ CLOCK/TIMER Before you set the clock, insert four size AA (R6) batteries and connect the AC power cord (see page 22. ) Before you set the clock, "AM 12:00" flashes. 1 2 3 Press CLOCK/TIMER until "CLOCK" appears in the display. Press CLOCK/TIMER for about 2 seconds until the hour digit flash. The "AM" or "PM" indication also flashes. Press TUNING/TIME SET +/­ until you set the current hour. Set the minutes by pressing TUNING/TIME SET +/­ until the correct minute is displayed. / 4 Press DISPLAY/ENTER. The clock starts from 00 seconds. 18 The Timer CFD-580. E_3-858-521-6X. CA2 Waking up to music DISPLAY/ CLOCK/ TUNING/ ENTER TIMER TIME SET+/­ STANDBY You can wake up to music or a radio program at a preset time. Make sure you have set the clock ("Setting the clock" on page 18). The Timer 1 Prepare the music source you want to play. To play the radio a CD Do this Tune in a station Insert a CD. 2 3 4 5 Press CLOCK/TIMER until "TIMER" appears in the display. The t (clock) and the music source ("Cd" or "RAdiO") flash. Select the music source ("Cd" or "RAdiO") by pressing TUNING/TIME SET +/­, then DISPLAY/ENTER. Set the timer to the hour you want the music to start by pressing TUNING/TIME SET +/­ then DISPLAY/ENTER. Set the minutes, then press DISPLAY/ENTER. 6 Press TUNING/TIME SET +/­ to set the volume, then DISPLAY/ENTER. continued The Timer 19 CFD-580. E_3-858-521-6X. CA2 Waking up to music (continued) Tip You can have the player go on the next day at the same time. Just press STANDBY until the t indication appears in the display. · Since a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or springwound watches away from the player to prevent possible damage from the magnet. On operation · If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player section. Should this occur, the player will not operate properly. In this case, remove the CD and wait about an hour for the moisture to evaporate. · If the player has not been used for a long time, set it in the playback mode to warm it up for a few minutes before inserting a cassette. If you have any questions or problems concerning your player, please consult your nearest Sony dealer. 24 Additional Information CFD-580. E_3-858-521-6X. CA2 Notes on CDs · Before playing, clean the CD with a cleaning cloth. Wipe the CD from the center out. Notes on cassettes · Break off the cassette tab from side A or B to prevent accidental recording. If you want to reuse the tape for recording, cover the broken tab with adhesive tape. Side A · Do not use solvents such as benzine, thinner, commercially available cleaners or anti-static spray intended for vinyl LPs. · Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be a considerable rise in temperature inside the car. · Do not stick paper or sticker on the CD, nor scratch the surface of the CD. · After playing, store the CD in its case. [. . . ] · If you are listening to an FM program near the TV with an indoor antenna, move the player away from the TV. General CD Player Radio There is no audio. "no disc" lights in the display even when a CD is in place. The CD does not play. The sound drops out. The audio is weak or has poor quality. The picture of your TV becomes unstable. 26 Additional Information CFD-580. E_3-858-521-6X. CA2 Symptom The tape does not move when you press an operation button. The REC r button does not function/The tape does not play. The tape does not erase completely. Remedy · Close the cassette compartment securely. [. . . ]