User manual SONY CFD-59

[. . . ] If you want to reuse the tape for recording, cover the broken tab with adhesive tape. ⷠMake sure the batteries are inserted correctly. ⷠReplace all the batteries with new ones if they are weak. ⷠYou cannot turn on the player with the remote when you operate the player on batteries. [. . . ] ⷠPlace the player in a location free from vibration. ⷠClean the lens with a commercially available blower. ⷠThe sound may drop out or noise may be heard when using poor quality CD-Rs/CDRWs or if there is a problem with the recording device or application software. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. Replace all the batteries in the remote with new ones if they are weak. ⷠMake sure that you are pointing the remote at the remote sensor on the player. ⷠRemove any obstacles in the path of the remote and the player. ⷠMake sure the remote sensor is not exposed to strong light such as direct sunlight or fluorescent lamp light. ⷠMove closer to the player when using the remote. ⷠIf you are listening to an FM programme near the TV with an indoor aerial, move the player away from the TV. With normal use, the batteries should last for about six months. When the remote no longer operates the player, replace all the batteries with new ones. With the side you want to play facing you AUTO PRESET until the band you want appears in the display (direct power-on). Each time you press the button, the indication changes as follows: CFD-S550: "FM" t "AM" CFD-59: "FM" t "MW" t "LW" Hold down TUNE + or ­ until the frequency digits begin to change in the display. The player automatically scans the radio frequencies and stops when it finds a clear station. If you can't tune in a station, press the button repeatedly to change the frequency step by step. tip If the FM broadcast is noisy, press MODE until "Mono" appears in the display and the radio will play in monaural. (On the remote, press OPERATE (or POWER) and then press FUNCTION repeatedly until "TAPE" appears in the display. Press xZ m or M X Press the button again to resume play after pause. (On the remote, press OPERATE (or POWER) and then press FUNCTION repeatedly until "Cd" appears in the display. [. . . ] You need to preset a station with a weak signal manually. 3 Hold down the number buttons that you want to preset the new station on for about 2 seconds. To select the preset number over 10, press >10 first, then the corresponding number buttons. You need to hold down the last number button to enter for about 2 seconds. [. . . ]