User manual SONY CFD-606

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. [. . . ] The clock starts from 00 seconds. The Timer 19 Waking up to music You can wake up to music or a radio program at a preset time. Make sure you have set the clock ("Setting the clock" on page 19). STANDBY TIMER TIME SET ­, + DISPLAY ENTER Before you begin, make sure the t (clock) indication is not lit in the display. If it is lit, press STANDBY. 1 Prepare the music source you want to play. To play a CD the radio Do this Insert a CD. Tune in a station 2 3 4 Press TIMER. The t (clock) and the music source ("Cd" or "RAdIO") flash. Select the music source ("Cd" or "RAdIO") by pressing TIME SET + or ­, then DISPLAY ENTER. Set the timer to the hour you want the music to start by pressing TIME SET + or ­, then DISPLAY ENTER. Set the minutes by pressing TIME SET + or ­, then DISPLAY ENTER. 5 Set the timer to the hour and the minutes you want the music to go off. (Do as step 4. ) 20 The Timer 6 Set the volume by pressing TIME SET + or ­, then DISPLAY ENTER. The Timer Tips · To exit the standby mode, press STANDBY to make the t indication disappear from the display. · The preset settings remain until you reset them. 7 Press STANDBY. The t indication lights up; the player enters the standby mode. At the preset time, the power will go on, and the music will play. On placement · Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. · Do not place the player on an inclined or unstable place. · Do not place anything within 10 mm of the side of the cabinet. The ventilation holes must be unobstructed for the player to operate properly and prolong the life of its components. · If the player is left in a car parked in the sun, be sure to choose a location in the car where the player will not be subjected to the direct rays of the sun. · Since a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or springwound watches away from the player to prevent possible damage from the magnet. On operation · If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player section. Should this occur, the player will not operate properly. In this case, remove the CD and wait about an hour for the moisture to evaporate. · If the player has not been used for a long time, set it in the playback mode to warm it up for a few minutes before inserting a cassette. If you have any questions or problems concerning your player, please consult your nearest Sony dealer. 28 Additional Information Notes on CDs · Before playing, clean the CD with a cleaning cloth. [. . . ] · The source which was recorded on TYPE II (high position) or TYPE IV (metal) tape using this unit is being played. Record on TYPE I (normal) tape and play. · Make sure the tape is inserted properly. · Make sure the safety tab of the cassette is in place. [. . . ]