User manual SONY CFD-68

[. . . ] Attempting to do so may damage the player. Do not use such discs. Notes on cassettes · Break off the cassette tab from side A or B to prevent accidental recording. If you want to reuse the tape for recording, cover the broken tab with adhesive tape. Troubleshooting General The power does not come on. · Make sure the batteries are inserted correctly. · Replace all the batteries with new ones if they are weak. [. . . ] · Replace all the batteries with new ones if they are weak. CAUTION The use of optical instruments with this product will increase eye hazard. On placement · Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. · Do not place the player on an inclined or unstable place. · Do not place anything within 10 mm of the side of the cabinet. The ventilation holes must be unobstructed for the player to operate properly and prolong the life of its components. · If the player is left in a car parked in the sun, be sure to choose a location in the car where the player will not be subjected to the direct rays of the sun. · Since a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or spring-wound watches away from the player to prevent possible damage from the magnet. · Do not use solvents such as benzine, thinner, commercially available cleaners or anti-static spray intended for vinyl LPs. · Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be a considerable rise in temperature inside the car. · Do not stick paper or sticker on the CD, nor scratch the surface of the CD. · After playing, store the CD in its case. If there is a scratch, dirt or fingerprints on the CD, it may cause tracking error. Pinch roller Erase head Radio section Frequency range FM: 87. 5 - 108 MHz AM: 530 - 1 710 kHz Antennas FM: Telescopic antenna AM: Built-in ferrite bar antenna WARNING Capstan Record/playback head CFD-68 Sony Corporation ©2002 Printed in China Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the appliance. The sound drops out. · Reduce the volume. Should this occur, the player will not operate properly. In this case, remove the CD and wait about an hour for the moisture to evaporate. · If the player has not been used for a long time, set it in the playback mode to warm it up for a few minutes before inserting a cassette. · Reorient the player itself to improve AM reception. Sony R20P: approx. 13. 5 h The audio is weak or has poor quality. · Replace all the batteries with new ones if they are weak. · Move the player away from the TV. Sony alkaline LR20: approx. 20 h Tape playback Sony R20P: approx. 15 h CD playback Preparing the remote C Insert two size AA (R6) batteries (not supplied). The picture of your TV becomes unstable. · If you are listening to an FM program near the TV with an indoor antenna, move the player away from the TV. Replacing battery With normal use, the batteries should last for about six months. When the remote no longer operates the player, replace all the batteries with new ones. Sony R20P: approx. 386 × 173 × 269 mm (w/h/d) (15 1/4 × 6 7/8 × 10 5/8 inches) (incl. batteries) Supplied accessory AC power cord (1) Remote control (1) Design and specifications are subject to change without notice. Location of controls Inserting a cassette With the side you want to play facing you Playing a CD Loading a CD Remote Control SLEEP FUNCTION Number buttons With the labeled side up * u* . , > TUNE ­, + x MODE VOL +*, ­ Z PUSH OPEN/CLOSE SOUND MODE X TUNE ­, + SOUND MEGA BASS MEGA BASS MEGA Xpand BAND MEGA Xpand . , > N x POWER Listening to the radio 1 Press RADIO BAND·AUTO PRESET until the band you want appears in the display (direct power-on). Each time you press the button, the indication changes as follows: "FM" t "AM" Hold down TUNE + or ­ until the frequency digits begin to change in the display. [. . . ] Be sure to turn off the power of each component before making connections. For details, refer to the instructions of the component to be connected. To check the remaining time Press DISPLAY·ENT·MEMORY repeatedly while playing a CD. The display changes as follows: t the current track number and playing time r the current track number and the remaining time on the current track* r the number of tracks left and remaining time on the CD Playing preset radio stations 1 2 Press RADIO BAND·AUTO PRESET to select the band. Press the number buttons to tune in the stored station. [. . . ]