User manual SONY CFD-7

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. [. . . ] Then create a new program following the programing procedure. 16 The CD Player The Radio Presetting radio stations FUNCTION POWER You can store radio stations into the player's memory. You can preset up to 20 radio stations, 10 for each FM or AM in any order. MODE CD/RADIO (AC ONLY) Number buttons The Radio VOL BAND BAND TUNE TUNE +/­ Tip To preset radio stations on the player, proceed as follows: 1 Select the band and tune in a station you want. 2 Hold down DISPLAY/ENTER/ MEM for about 2 seconds. A preset number flashes in the music calendar. 3 Decide on a preset number for the station (1 to 10) by pressing PRESET +/­. 4 Press DISPLAY/ ENTER/MEM. 1 2 3 Press BAND until the band you want appears in the display. Hold down the number buttons that you want to preset the new station for about 2 seconds. The new station replaces the old one. The Radio 17 Playing preset radio stations FUNCTION POWER Once you've preset the stations, use the number buttons to tune in your favorite stations. CD/RADIO (AC ONLY) Number buttons MODE VOL BAND TUNE BAND Tip You can tune in a preset station with the player. Use PRESET +/­ instead of the number buttons. 1 2 Press BAND to select the band. Press the number buttons to tune in a stored station. 18 The Radio The Tape Player Recording through a microphone/Using as a PA system You can record sound using a microphone (not supplied) or use the player as a public address (PA) system. MODE FUNCTION POWER POWER (AC ONLY) CD/RADIO FUNCTION The Tape Player VOL BAND TUNE Tip You can mix CD or radio sounds and record them by adding your voice or other audio through the microphone. Notes · Acoustic feedback (howling) tends to occur when you use a microphone with echo function. You can get the surround effect without connecting surround speakers. 28 Setting Up Additional Information Precautions On safety · As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. Refer servicing to qualified personnel only. · Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further. On power sources · For AC operation use the supplied AC power cord; do not use any other type. · The player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off. · Unplug the player from the wall outlet when it is not to be used for an extended period of time. · For battery operation, use eight size D (R20) batteries. · When the batteries are not to be used, remove them to avoid damage that can be caused by battery leakage or corrosion. · The nameplate indicating operating voltage, power consumption, etc. On placement · Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. · Do not place the player on an inclined or unstable place. [. . . ] · Clean the erasing head (see page 33. ) · Replace all the batteries with new ones if they are weak. · Make sure the tape is inserted properly. · Make sure the safety tab of the cassette is in place. · Clean the heads, pinch rollers and capstans (See page 33). [. . . ]