User manual SONY CFD-757

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. [. . . ] 2 Hold down DISPLAY/ENTER for about 2 seconds. 3 Decide on a preset number for the station (1 to 10) by pressing PRESET +/­. A preset number flashes in the music calendar. 4 Press DISPLAY/ ENTER. 1 2 3 Press BAND until the band you want appears in the display. Hold down the number buttons that you want to preset the new station for about 2 seconds. The new station replaces the old one. The Radio 17 CFD-757. E_3-858-522-6X. U/CA/AU6/TW Playing preset radio stations Once you've preset the stations, use the number buttons to tune in your favorite stations. Number buttons BAND Tip You can tune in a preset station with the player. Use PRESET +/­ instead of the number buttons. 1 2 Press BAND to select the band. Press the number buttons to tune in a stored station. 18 The Radio CFD-757. E_3-858-522-6X. U/CA/AU6/TW The Timer Setting the clock DISPLAY/ENTER CLOCK/TIMER TUNING/TIME SET +/­ Before you set the clock, insert four size AA (R6) batteries and connect the AC power cord (see pages 23 and 24. ) Before you set the clock, "AM 12:00" flashes. The Timer 1 2 3 Press CLOCK/TIMER until "CLOCK" appears on the display. Press CLOCK/TIMER for about 2 seconds until the hour digit flashes. The "AM" or "PM" indication also flashes. Press TUNING/TIME SET +/­ until you set the current hour. · Unplug the player from the wall outlet when it is not to be used for an extended period of time. · For battery operation, use eight size C (R14) batteries. · When the batteries are not to be used, remove them to avoid damage that can be caused by battery leakage or corrosion. · The nameplate indicating operating voltage, power consumption, etc. On placement · Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. · Do not place the player on an inclined or unstable place. · Do not place anything within 10 mm of the side of the cabinet. The ventilation holes must be unobstructed for the player to operate properly and prolong the life of its components. · If the player is left in a car parked in the sun, be sure to choose a location in the car where the player will not be subjected to the direct rays of the sun. · Since a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or springwound watches away from the player to prevent possible damage from the magnet. On operation · If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player section. [. . . ] · Make sure "TAPE" appears in the display. · Clean the erasing head (see page 30. ) · Replace all the batteries with new ones if they are weak. · Make sure the tape is inserted properly. · Make sure the safety tab of the cassette is in place. [. . . ]