User manual SONY CFD-9

[. . . ] After all the indications in the display disappear, plug the AC power adaptor and insert the batteries again. If the problem persists, please consult your nearest Sony dealer. Information For customers in the USA This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the Noise is heard. · Someone is using a portable telephone or other equipment that emits radio waves near the player. tMove the portable telephone, etc. , away from the player. Cleaning the cabinet · Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as alcohol or benzine. Notes on CDs · Before playing, clean the CD with a cleaning cloth. · Do not use solvents such as benzine, thinner, commercially available cleaners or anti-static spray intended for vinyl LPs. · Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be a considerable rise in temperature inside the car. · Do not stick paper or sticker on the CD, nor scratch the surface of the CD. · After playing, store the CD in its case. If there is a scratch, dirt or fingerprints on the CD, it may cause tracking error. equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. 315 × 131 × 70 mm (w/h/d) (12 5/8 × 5 1/4 × 2 7/8 inches) (incl. batteries) Supplied accessory AC power adaptor (1) Design and specifications are subject to change without notice. Optional accessories Sony MDR headphone series On placement · Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. · Do not place the player on an inclined or unstable place. · Do not place anything within 10 mm of the side of the cabinet. The ventilation holes must be unobstructed for the player to operate properly and prolong the life of its components. · If the player is left in a car parked in the sun, be sure to choose a location in the car where the player will not be subjected to the direct rays of the sun. · Since a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or spring-wound watches away from the player to prevent possible damage from the magnet. Lens Radio section Frequency range FM: 87. 5 - 108 MHz AM:530 - 1, 710 kHz Antennas FM: Telescopic antenna AM: Built-in ferrite bar antenna Location of controls i (headphones) TUNING Choosing Power Sources Connecting the AC power adaptor Playing a CD To adjust the volume stop playback Do this Slide VOL. Press the button again to resume play after pause. Press . . Listening to the radio 1 Turn on the player. wall outlet pause playback MEGA BASS VOL* POWER FUNCTION 1 Turn on the player. 1 to DC IN 2 to a 6V PLAY MODE go to the next track go back to the previous track OPR/BATT AC power adaptor (supplied) 2 Press Z to open the CD compartment. , locate a point while Press > (forward) or . listening to the sound (backward) while playing until you find the point. [. . . ] Set POWER to "OFF". 2 Set FUNCTION to "FM STEREO" or "AM". To remove the CD Be careful not to touch the playing side (the side with no label). Using the player on batteries Display ** DC IN 6V PUSH CLOSE Insert four size AA (R6) batteries (not supplied) into the battery compartment. To release the battery Press the # side of the battery and then take out the battery. 3 Place a CD in the CD compartment. 12 cm CD Push down until it clicks into place. 8 cm CD Insert aligning the center part. Selecting play mode 1 Set FUNCTION to "CD". 2 Press PLAY MODE until the play mode you want appears in the display. Then proceed as follows: 3 Turn TUNING to tune in a radio station. * There is a tactile dot beside VOL to show the direction to turn up the volume. ** The u button has a tactile dot. To listen through headphones Connect the headphones to the i (headphones) jack. If the battery compartment lid comes off Insert the right corner of the lid and then insert the left corner aligning it to the groove of the battery compartment. To With the label side facing you repeat a single track Selected play mode and operation you need "REP 1": Select the track you want to repeat by pressing > or . [. . . ]