User manual SONY CFD-V20

[. . . ] To prevent fire or shock hazard, do not expose the player to rain or moisture. For customers in the United States This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Press p once if the CD is stopped and twice if the CD is playing. Then create a new program following the programing procedure. You can use the AC power or batteries as a power source. Use the AC power source whenever you record since recording consumes much power. Insert one end of the supplied AC power cord to the AC IN socket located at the rear of the player, and the other end to the wall outlet. Replacing batteries With normal use, the batteries should last for about six months. When the remote no longer operates the player, replace all the batteries with new ones. Tip Replace the batteries when the OPR/BATT indicator dims or when the player stops operating. replace all the batteries with new ones. Before you replace the batteries, be sure to take out the CD from the player. Using the player on batteries Insert six size D (R20) batteries (not supplied) into the battery compartment. To use the player on batteries, disconnect the AC power cord from the player. Turn the control clockwise to enhance the high tone and counterclockwise to enhance the low tone. To return to normal sound, press the button again. As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further. on power sources · For AC operation, use the supplied AC power cord; do not use any other type. ⷠThe player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off. ⷠUnplug the player from the wall outlet when it is not to be used for an extended period of time. ⷠFor battery operation, use six size D (R20) batteries. ⷠWhen the batteries are not to be used, remove them to avoid damage that can be caused by battery leakage or corrosion. Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. [. . . ] Make sure the safety tab on the cassette is in place. ) · Replace all the batteries with new ones if they are weak. The picture of your TV becomes unstable. The CD does not play/"no disc" lights in the display even when a CD is in place. [. . . ]