User manual SONY CFS-B21L

[. . . ] A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, same rating fuse approved by ASTA or BSI to BS 1362, (i. [. . . ] â· For AC operation, use the supplied mains lead; do not use any other type. â· The player is not disconnected from the mains as long as it is connected to the mains, even if the player itself has been turned off. When the batteries are not to be used, remove them to avoid damage that can be caused by battery leakage or corrosion. Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. â· Do not place anything within 10 mm of the side of the cabinet. The ventilation holes must be unobstructed for the player to operate properly and to prolong the life of its components. â· Since a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or spring-wound watches away from the player to prevent possible damage from the magnet. â· If the player has not been used for a long time, set it in the playback mode to warm it up for a few minutes before inserting a cassette. If you have questions or problems concerning your player, please consult your nearest Sony dealer. Make sure the safety tab on the cassette is in place. Clean the unit (as shown) with a cotton swab slightly moistened with cleaning fluid or alcohol. â· Demagnetize the heads and all metal parts in the tape path with a commercially available tape head demagnetizer. [. . . ] If the MW or LW programme makes a whistling sound, set FM MODE/ISS (Interference Suppress Switch, at the rear) to the position that most decreases the noise. While recording from the built-in microphone, you cannot monitor the sound through the headphones. [. . . ]