User manual SONY CFS-205

[. . . ] Tips · For best results, use the mains lead. · Do not set the FUNCTION during dubbing as this causes excessive wow and flutter. · Adjusting the volume will not affect the recording level. [. . . ] · When the tape in deck A ends first, deck B will also stop recording. When the tape in deck B ends first, deck A will contiune to play. Tips · For best results, use the AC power source. · Adjusting the volume or the tone will not affect the recording level. Tips · To listen through the headphones, connect the headphones to PHONES. ·For best results, move the player away the TV. Tip When you play both decks, you will only hear deck B. Note · While recording from the built-in microphone, you cannot monitor the sound through the headphones. · Do not press 0, ) or 9 on deck A during recording as this causes excessive wow and flutter. Note Do not press 0, ) or 9 on the other deck during playback as this causes excessive wow and flutter. Notes on cassettes · Break off the cassette tab from side A or B to prevent accidental recording. If you want to reuse the tape for recording, cover the broken tab with adhesive tape. Side A Tab for side B Tab for side A · The use of a cassette with more than 90 minutes of play time is not recommended except for long, continuous recording or playback. Choosing Power Sources To use the player on AC power source Connect the supplied AC power cord to the AC IN jack. WARNING Owner's Record The model number is located on the bottom, and the serial number is located in the battery compartment. Record the serial number in the space provided below. · If the player has not been used for a long time, set it in the playback mode to warm it up for a few minutes before inserting a cassette If you have questions or problems concerning your player, please consult your nearest Sony dealer. Insert six R20 (size D) batteries (not supplied) into the battery compartment. Notes · To use the player on batteries, disconnect the AC power cord from the player. · Replace the batteries when the OPR/BATT indicator dims or when the player stops operating. Replace all the batteries with new ones. 3-856-628-71(1) For customers in Canada To prevent electric shock, match wide blade of plug to wide slot, fully insert. Troubleshooting There is no audio. · Connect the AC power cord securely. · Replace all the batteries if they are weak. · Set FUNCTION to the position you want to operate. Specifications AUDIO POWER SPECIFICATIONS Erase head Capstan POWER OUTPUT AND TOTAL HARMONIC DISTORTION: With 3. 2ohm loads, both channels driven, from 150­ 10, 000Hz; rated 1. 5 watts per channel minimum RMS power, with no more than 10% total harmonic distortion in AC operation. · Frequency range FM: 87. 6­108MHz AM: 530­1, 710kHz · Antennas FM: Telescope/AM: Built-in ferrite bar · Recording system 4-track, 2channel stereo · Frequency response 80­10, 000Hz · Speakers Fullrange: 10cm (4inches) dia. , cone type · Output Headphones jack(stereo minijack), for 16­32 ohms impedance headphones · Power output (excluding the USA model) 2. 3W+2. 3W (at 10% harmonic distortion in DC operation) · Battery life FM Recording: Sony R20P: Approx. [. . . ] , cone type · Output Headphones jack(stereo minijack), for 16­32 ohms impedance headphones · Power output (excluding the USA model) 2. 3W+2. 3W (at 10% harmonic distortion in DC operation) · Battery life FM Recording: Sony R20P: Approx. 12 hours · Power requirements Australian model: 230­240 V AC, 50Hz/Other models: 120 V AC, 60Hz 9V DC, six size D (R20) batteries · Power consumption AC 14W · Dimensions Approx. 540 x 159 x 163 mm (w/h/d) ( 213/8 x 63/8 x 61/2 inches) incl. [. . . ]