User manual SONY CFS-902

[. . . ] When you turn on the player, the OPR/BATT indicator lights up. Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further. â· For AC operation, check that the player's operating voltage is identical with your local power supply (see "Specifications") and use the supplied mains lead; do not use any other type. The player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off. [. . . ] When the batteries are not to be used, remove them to avoid damage that can be caused by battery leakage or corrosion. Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. â· Do not place anything within 10 mm of the side of the cabinet. The ventilation holes must be unobstructed for the player to operate properly and to prolong the life of its components. â· Since a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or springwound watches away from the player to prevent possible damage from the magnet. â· If the player has not been used for a long time, set it in the playback mode to warm it up for a few minutes before inserting a cassette. If you have questions or problems concerning your player, please consult your nearest Sony dealer. Get powerful, clear sounds emphasizing low and high range audio. Align the grooves and slide the speaker box down until it snaps into place a. Get light, bright sounds emphasizing high and middle range audio. With the side you want to record facing you. To tune in an SW band, use FINE TUNING for better SW reception. To Press p6 STOP/EJECT ) FF or 0 REW P PAUSE Press this button again to resume playback . For best results, use the AC power source. If the MW or LW programme makes a whistling sound, set ISS (Interference Suppress Switch) or FM MODE/ISS (at the rear) to the position that more decreases the noise. Press p6 STOP/EJECT on deck B P PAUSE on deck B Press this button again to resume recording. When you play both decks, you will hear only deck B. Do not press ) FF, 0 REW or ( PLAY on the other deck during playback as this causes excessive wow and flutter. While recording from the built-in microphone, you cannot monitor the sound through the headphones. â· Do not press ) FF, 0 REW or ( PLAY on deck A during recording as this causes excessive wow and flutter. [. . . ] While recording from the built-in microphone, you cannot monitor the sound through the headphones. â· Do not press ) FF, 0 REW or ( PLAY on deck A during recording as this causes excessive wow and flutter. Break off the cassette tab from side A or B to prevent accidental recording. If you want to reuse the tape for recording, cover the tab hole with adhesive tape. [. . . ]