User manual SONY CHC-P33D

[. . . ] Proper speaker positioning is essential in order to achieve directional effects and diffused ambiance. When you install the speakers, refer to the following instructions. once you have determined the final placement , fasten the speakers to the speaker stands. [. . . ] On condensation in the CD player component If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player. Should this occur, the CD player will not operate. Remove the CD and leave the system turned on for about an hour until the moisture evaporates. To save a tape permanently To prevent a tape from being accidentally recorded over, break off the cassette tab from side A or B as illustrated. If you later want to reuse the tape for recording, cover the broken tab with adhesive tape. If you run into any problem using the stereo, use the following check list and first check the following points: · Should any problem persist after you have made the checks below, consult your nearest Sony dealer. A stereo FM programme cannot be received in stereo. The tape does not record nor playback or there is a decrease in sound level. There is excessive wow or flutter, or the sound drops out. Noise increases or the high frequencies are erased. When you are using a type II (CrO2) tape, be careful not to cover the detector slots which allow the tape player to automatically detect the type of tape. Leave the system turned on for about an hour until the moisture evaporates. Play does not start from the first track. Turn the jog dial counterclockwise (or press = on the remote) to return to the normal display. [. . . ] To clean the cabinet Use a soft cloth slightly moistened with mild detergent solution. Tape player section Recording system 4-track 2-channel stereo Frequency response (DOLBY NR OFF) 40 ­ 13, 000 Hz (±3 dB), using Sony TYPE I cassette 40 ­ 14, 000 Hz (±3 dB), using Sony TYPE II cassette Wow and flutter 0. 3% (DIN) Amplifier section DIN power output: Satellite: 7 W + 7 W (4 ohms at 1 kHz, DIN) Superwoofer: 30 W (6 ohms at 60 Hz, DIN) Continuous RMS power output Satellite: 10 W + 10 W (4 ohms at 1 kHz, 10% THD) Superwoofer: 35 W (6 ohms at 60 Hz, 10% THD) Music power output Satellite: 15 W + 15 W (4 ohms at 1 kHz, 10% THD) Superwoofer: 45 W (6 ohms at 60 Hz, 10% THD) Inputs MD IN: Sensitivity 450 mV, impedance 47 kilohms Outputs MD OUT: Sensitivity 250 mV, 1 k PHONES (stereo phone jack): accept headphones of 8 ohms or more. [. . . ]