User manual SONY CMR-PC1 USB

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. 92/ 31/EEC This equipment complies with the EMC regulations when used under the following circumstances: · Licensed software from Luxxon Corporation is included in this package. (Copyright 1999) All rights reserved Luxxon Corporation 2055 Gateway Place , Suite 350 San Jose , CA 95110 , USA · Other system names and product names appearing in this document are generally registered trademarks or trademarks of their manufacturers, although TM and ® marks are not shown in this document. Before using this camera, please read the Software License Agreement that is printed in these Operating Instructions. [. . . ] When using your camera on a sandy beach or dusty location, be sure that the camera is not exposed to sand or dust. Sand or dust may cause the camera to malfunction and sometimes the malfunction cannot be repaired. Keep the unit away from strong magnetic fields. Immediately after it is brought from a cold to a warm location, or if the temperature of the room is raised rapidly. Moisture may condense inside the camera. Observe the following precautions to protect the data recorded on discs. Do not touch the side of the disc with recorded data (playback side). Do not disconnect the camera's USB cable while the application is in operation. Do not place objects on top of your camera. Do not use your camera Do not store a disc where it is subject to excessive dust, direct sunlight, high humidity, or near heat sources. To protect valuable data, always place the disc in its case for storage. If very dirty, use a soft cloth slightly moistened with a mild detergent solution. do not use thinner , benzine , alcohol , etc. As these can damage the finish of the camera. Fingerprints and dust on the surface of a disc may cause read errors. For normal cleaning, hold the disc by its edge and use a soft cloth to wipe the surface from the centre out. Clean the lens surface with a blower brush or a soft brush to remove dust. If very dirty, use a commercially available lens cleaning cloth. If the disc is very dirty, moisten a soft cloth with water, wring it out well, and use it to wipe the surface of the disc from the center out. Wipe off any remaining moisture with a dry soft cloth. Do not use solvents such as benzine, thinner, commercially available cleaners or anti-static spray, as they may cause damage to the disc. 8 mm (f = 40 mm, when converted into a 35 mm still camera) White balance Auto/Indoor/Outdoor/Hold Shutter speed Auto/Fixed/Hold Video capture formats/sizes YUY2/RGB 24 bits/UYVY 40 × 30, 80 × 60, 160 × 120, 320 × 240, 640 × 480 Display frame rate Max. [. . . ] Video memory has become insufficient due to the computer's image mode or number of colours, or as a result of other circumstances. If the images from the camera do not appear even after performing the above steps, restart the computer. T Click [Cancel] of the [Add New Hardware Wizard], and then remove the USB cable from the USB connector. Then install the driver by following the procedure described in "Installing the Drivers, "Camera Setting Utility" and "SONY USB CAMERA Viewer"" (see page 6). [. . . ]