User manual SONY CMT-C7NT

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. this appliance is classified as a CLASS 1 LASER product. This label is located on the bottom exterior. [. . . ] Note, however, that you cannot undo an edit if you do any of the following after the edit: · For example, to combine track 1 to 4, select 4. Second track number of the two to be combined appears. Second track number to be combined New track number Tracks recorded in different recording modes (STEREO, LP2, LP4 or MONO) cannot be combined. If both of the combined tracks have track titles, the title of the second track is erased. If two tracks registered to different groups are combined, the second track is registered to the group in which the first track is registered. (The status of the second track is determined by the status of the first track. " does not appear, when there is no editing function that can be canceled. You can change the volume of the recorded tracks using S. The original track is recorded over at the new recording level. When changing the recording level, you can select Fade-in Recording to gradually increase the signal level at the start of recording, or Fade-out Recording to gradually decrease the signal level at the end of the recording. You cannot change the recording level of the track recorded in MDLP mode. The track number you want to change the recording level of, and then press ENTER/YES on the remote. The recording level can be adjusted from ­12 dB to +12 dB in 2 dB increments. Adjust the recording level so as not to light up "OVER" at the strongest sound. F Edit: **%" appears while the track is being recorded. An amount of time that is roughly equal to or longer than the playing time of the track is required when recording over the track. Changing the overall recording level of a track Press MENU/NO on the remote during steps 4 through 8. If you press ENTER/YES on the remote in step 9 and start recording, you cannot interrupt the operation. Press MENU/NO on the remote during steps 4 through 8. After recording starts in step 9, you cannot interrupt the operation. Do not disconnect the power cord or move the system while recording is in progress. This may damage the recording data, preventing recording from being performed properly. [. . . ] If you want to turn off the power during editing, press `/1 again while the message is displayed. Adjustment of the recording level after recording or Fade-in and Fade-out procedures have failed since the unit was either subject to vibration or there is a damaged or dirty disc in the tray. place the unit in a stable place to minimize shock and vibration. The signal was input again after silence continued for 3 or more but less than 30 seconds during digital recording. [. . . ]