User manual SONY CMT-CP2W

[. . . ] The model and serial numbers are located on the rear of the unit. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] You can also use Repeat Play function while in Shuffle Play or Program Play. Each time you press this button, the display changes as follows: The following table describes the two repeat modes. To repeat All the tracks on the CD Only the currently playing track Press REPEAT repeatedly until "REPEAT" appears. T Current track number and elapsed playing time of the track r Current track number and remaining playing time of the track r Remaining playing time of the entire CD r Clock display Each time you press DISPLAY while the CD and tape units are stopped, the display changes as follows: t Total playing time* r Clock display r Current source display * It appears only when "CD" is selected. If the CD contains 25 tracks or more, the remaining playing time of the current track will appear as "- - . - -" for each track starting with the 25th. Playing CD tracks in random order -- Shuffle Play You can use this function to playback all the tracks on a CD in random order. Playing CD tracks in a favorite order â­Â­ Program Play You can make a program of up to 24 tracks on a CD in any order that you want. After setting the order, you can also make a synchronized tape recording of the tracks (see page 21). ";" appears while the next track is being selected, and all the tracks play in random order. Or CD > repeatedly until the desired track number appears. You can also start Shuffle Play during Normal Play by selecting "SHUFFLE". Selected track number Total playing time You cannot go back to the preceding track by pressing CD . Playing CD tracks in a favorite order (continued) Do the procedure below to manually record from any source to a tape. For example, tracks from a CD, the radio, or from any of the connected components. This lets you record just the songs that you want from a CD. The tracks play in the order that they were programmed. Add a track to the end Do steps 3 and 4 with of the program Program Play stopped. Erase the entire program Press CD x with Program Play stopped. The program you made remains in the system's memory until you turn off the system or remove the CD. After the program finishes, press CD u to play the program again. â· When the total playing time of the programmed tracks exceeds 100 minutes, "- - . [. . . ] â· You are not pointing the remote in the direction of the system's sensor. Make sure that the batteries are inserted correctly. Sound comes from only one channel, or the left and right volumes are unbalanced. Remove the CD and leave the system turned on for about an hour until the moisture evaporates. [. . . ]