User manual SONY CMT-CP500MD

[. . . ] The model and serial numbers are located on the rear of the unit. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] Repeatedly to select the track number you want to Fade-in or Fade-out, then press ENTER/YES on the remote. Do not disconnect the power cord or move the system while recording is in progress. This may damage the recording data, preventing recording from being performed properly. Do not use an MD that is damaged or dirty, this may prevent data from being recorded properly. Repeatedly changing the recording level results in poor sound quality. The recording level will not return to the exact original level once the recording level has been changed even if it is returned to the original level. While the timer is activated, you cannot change the recording level. You cannot return to the original condition after changing the recording level. The system plays the portion that will be recorded over using the Fade-in or Fade-out Recording. You can set the time at any value between 1. You cannot set the time longer than the track. F Edit: **%" appears while the track is being recorded. Press MENU/NO on the remote during step 2 through 8. After recording starts in step 9, you cannot interrupt the operation. In step 3, press TUNING MODE repeatedly until "AUTO" and "PRESET" disappear from the display, then press TUNING ­ or + repeatedly to tune in the station. To switch the AM tuning interval, tune in any AM station first, then turn off the system. Pressing and holding down REPEAT, turn the system back on. When you change the interval, all the AM preset stations are erased. To change back to the original interval, repeat the same procedure. Scanning stops automatically when a station is tuned in. The stations are stored from preset number 1. The preset stations are saved in the system's memory for about a day even if you disconnect the power cord or a power failure occurs. [. . . ] place the unit in a stable place to minimize shock and vibration. f Edit (adjusting the recording level after recording , Fade-in and Fadeout). F Edit is finished, the editing will not be properly overwritten. Turn the power off after editing is complete. [. . . ]