User manual SONY CMT-CP505MD

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. US and foreign patents licensed from Dolby Laboratories. The following caution label is located inside the apparatus. [. . . ] You can use this function to combine 2 tracks into a single track. The total number of tracks decreases by one and all tracks following the combined ones are renumbered. To shift the point by minute or second intervals in step 6 , press m or M on the remote repeatedly to flash minute, second, or frame indication, then press . If you divide a labelled track (page 28) into two tracks, only the first track retains the track title. The new track is not labelled You can use this function to cancel the last edit and restore the contents of the MD to the condition before the edit. Note, however, that you cannot undo the edit if you do any of the following after the edit: · Repeatedly until the first track number of the two to be combined appears, then press ENTER/YES on the remote. For example, to combine track 1 to 4, select 4. First track number Repeatedly until the second track number of the two to be combined appears. " does not appear when there is no editing function that can be cancelled. Second track number to New track number be continued Labelling discs, tracks or groups Erasing the titles Creating a new group Releasing a group Releasing all groups Deleting all the tracks Deleting a track Deleting a portion of a track Moving tracks Dividing a track Combining tracks When you combine two tracks that are registered into different groups, the second track is re-registered into the group containing the first track. In addition, if you combine a track that is registered to a group with a track that is not registered to a group, the second track takes the same registration setting as the first track. However, when the Group Function is on, you can only combine tracks within the selected group. Tracks recorded in different recording modes (stereo, LP2, LP4 or MONO) cannot be combined. If both of the combined tracks have track titles, the title of the second track is erased. The original track is recorded over at the new recording level. When changing the recording level, you can select Fade-in Recording to gradually increase the signal level at the start of recording, or Fade-out Recording to gradually decrease the signal level at the end of the recording. The recording level can be changed from ­12 dB to +12 dB, in 2 dB steps. Change to the optimum level while making sure that "OVER" does not appear in the display at the loudest portion. Adjust the level so as not to light up "OVER" F Edit: ** %" appears while the track is being recorded. An amount of time that is roughly equal to or longer than the playback time of the track is required when recording over the track. Repeatedly until the track number you want to change the recording level appears, then press ENTER/YES on the remote. You cannot change the recording level of the tracks recorded in MDLP mode. [. . . ] Track numbers cannot be marked Even in the Level Synchro Recording, the track numbers may not be marked at the beginning of the track: · If the input signal is below a certain fixed level for less than 2 seconds between tracks. If the input signal is below a certain fixed level for more than 2 seconds in the middle of the track. If you record a track that is 4 seconds or less*. This means there are insufficient characters for group management. [. . . ]