User manual SONY CMT-CPZ1DAB

[. . . ] Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) If your country or region does not support DAB broadcast, "No Service" appears. Do not press any button on the unit or the remote during DAB Automatic Scan. Scanning is interrupted and service list may not be created properly. In this case, run the DAB Automatic Scan again. [. . . ] Use buttons on the remote to create your own program. You can record on a TYPE I (normal) tape in two ways: Press repeatedly to set the hour, and then press ENTER . Use the procedure above to set the minute. 1 Make sure the power cord and speaker cords are Turn off CD player power by using the CD power management function. you cannot change the setting in Power Saving Mode. Use buttons on the unit to turn off CD player power. 2 Find your problem in the checklist below, and take You can record an entire CD onto a tape. You can record just the portions you like from a sound source, including connected audio components. Use buttons on the unit to control tape recording. When programming MP3 files, press +/ repeatedly to select the desired group, and then select the desired file. 1 Load a recordable tape with the side you want to 6 Select the sound source or prepare the tape. For Play Timer: Press / repeatedly until the desired sound source appears, and then press ENTER . Press DIRECTION on the unit repeatedly and select "" to record on one side, or "" or "" to record on both sides. To switch the recording sides of the tape, press (play) repeatedly ("" appears for recording on the front, and "" for the reverse side), and then press (stop) . Press DIRECTION on the unit repeatedly and select "" to record on one side, or "" or "" to record on both sides. To switch the recording sides of the tape, press TAPE (play) repeatedly ("" appears for recording on the front, and "" for the reverse side), and then press TAPE (stop) . Immediately unplug the power cord, and check the following item. If your system has a voltage selector, is the voltage selector set to the correct voltage? are the + and speaker cords short-circuited?Are you using only the supplied speakers? is anything blocking the ventilation holes on the rear of the system?After the STANDBY indicator stops flashing, reconnect the power cord, and turn on the system. [. . . ] 5 Repeat steps 1 through 4 to store other stations. you can preset up to 20 DAB , 20 FM and 10 AM stations. The preset stations are retained for about half a day even if you disconnect the power cord or if a power failure occurs. You cannot activate both the Play Timer and the Rec Timer at the same time. [. . . ]