User manual SONY CMT-CPZ2

[. . . ] Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) When you turn on the system, the disc is not pulled into the disc slot until "NO DISC" appears in the display. Do not attempt to push in the disc until "NO DISC" appears. If you load a disc that is not playable by this system, it will be ejected automatically. Do not load an 8 cm disc with an adaptor. [. . . ] OVER : You have reached the end of the disc while pressing (fast forward) during playback or pause. PUSH SELECT : You tried to set the clock or timer during timer operation. pUSH STOP : You pressed PLAY MODE during playback. SET CLOCK : You tried to select the timer when the clock is not set. SET TIMER : You tried to select the timer when the Play Timer or Rec Timer is not set. STEP FULL : You tried to program more than 25 tracks or files (steps). Press / repeatedly to set the hour, and then press ENTER . Use the procedure above to set the minute. 1 Make sure the power cord and speaker cords are 2 Find your problem in the checklist below, and take While the player is stopped. You can record an entire CD onto a tape. You can record just the portions you like from a sound source, including connected audio components. Use buttons on the unit to control tape recording. When programming MP3 files, press +/ repeatedly to select the desired group, and then select the desired file. 1 Load a recordable tape with the side you want to 6 Select the sound source or prepare the tape. For Play Timer: Press / repeatedly until the desired sound source appears, and then press ENTER . Press DIRECTION on the unit repeatedly and select "" to record on one side, or "" or "" to record on both sides. To switch the recording sides of the tape, press (play) repeatedly ("" appears for recording on the front, and "" for the reverse side), and then press (stop) . Press DIRECTION on the unit repeatedly and select "" to record on one side, or "" or "" to record on both sides. To switch the recording sides of the tape, press TAPE (play) repeatedly ("" appears for recording on the front, and "" for the reverse side), and then press TAPE (stop) . Immediately unplug the power cord, and check the following item. If your system has a voltage selector, is the voltage selector set to the correct voltage? are the + and speaker cords short-circuited? [. . . ] This function works even if the clock is not set. If you select "AUTO, " the system automatically turns off after the current disc or tape stops or in 100 minutes. Turn off CD player power by using the CD power management function. you cannot change the setting in Power Saving Mode. [. . . ]