User manual SONY CMT-CPZ3

[. . . ] 4-178-679-12(1) Micro HI-FI Component System Operating Instructions GB Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) Note on DualDiscs This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The recycling of materials will help to conserve natural resources. [. . . ] STEP FULL : You tried to program more than 25 tracks or files (steps). TIME NG : The Play Timer or Rec Timer start and end times are set to the same time. On placement Using the Timers The system offers three timer functions. You cannot activate both the Play Timer and the Rec Timer at the same time. If you use either with the Sleep Timer, the Sleep Timer has priority. 1 Make sure the power cord and speaker cords are correctly and firmly connected. 2 Find your problem in the checklist below, and take 1 Press CD to select the CD function. 2 Press PLAY MODE repeatedly until "PGM" appears while the player is stopped. CD Synchro Recording: Manual Recording: You can record an entire CD onto a tape. You can record just the portions you like from a sound source, including connected audio components. Use buttons on the unit to control tape recording. the indicated corrective action. If the issue persists, contact your nearest Sony dealer. Sleep Timer: If the STANDBY indicator flashes 3 Press / repeatedly until the desired track number appears. When programming MP3 files, press +/ repeatedly to select the desired group, and then select the desired file. 1 Load a recordable tape with the side you want to record facing forward. You can fall asleep to music. This function works even if the clock is not set. If you select "AUTO, " the system automatically turns off after the current disc or tape stops or in 100 minutes. 2 Prepare the tape deck for recording. Press FUNCTION repeatedly to select the tape function. Press DIRECTION on the unit repeatedly and select "" to record on one side, or "" or "" to record on both sides. To switch the recording sides of the tape, press TAPE (play) repeatedly ("" appears for recording on the front, and "" for the reverse side), and then press TAPE (stop) . Play Timer: Rec Timer: You can wake up to CD, tape or tuner at a preset time. You can record a preset radio station at a specified time. Use buttons on the remote to control the Play Timer and the Rec Timer. Make sure you have set the clock. Immediately unplug the power cord, and check the following item. If your system has a voltage selector, is the voltage selector set to the correct voltage? Are the + and speaker cords short-circuited? Are you using only the supplied speakers? Is anything blocking the ventilation holes on the rear of the system?After the STANDBY indicator stops flashing, reconnect the power cord, and turn on the system. If the issue persists, contact your nearest Sony dealer. Do not place the system in an inclined position or in locations that are extremely hot, cold, dusty, dirty, or humid or lacking adequate ventilation, or subject to vibration, direct sunlight or a bright light. [. . . ] Turn off nearby electrical equipment. Press TAPE (stop) or CD (stop) (for CD Synchro Recording only). To activate or check the timer again Discs that this system CANNOT play To pause recording (Manual Recording only) Press TAPE (pause) . Preset number Notes Press CLOCK/TIMER SELECT , press / repeatedly until "PLAY SEL" or "REC SEL" appears, and then press ENTER . 3 Press +/ repeatedly to select your desired preset number. If another station is already assigned to the selected preset number, the station is replaced by the new station. Recording stops if you change to a different function. You cannot eject the disc during CD Synchro Recording. If you stop the CD Synchro Recording by pressing CD (stop) , the tape stops after making about a 4 seconds blank (unrecorded) space before stopping. [. . . ]