User manual SONY CMT-CX4IP

[. . . ] If you move to another area, repeat this procedure to store the stations for your new area. this procedure clears all previously stored presets. Before unplugging the DAB antenna, make sure the system is turned off to preserve your own DAB settings. This tuner does not support data services. [. . . ] note You cannot make a digital recording of copy guarded discs and MP3 tracks using a digital component connected to this system. When you turn on the system for the first time after you purchase the system, DAB Automatic Scan starts automatically and creates a list of available services. If you want to run the DAB Automatic Scan again, perform the procedure below. Find a location and an orientation that provide good reception, and then set up the antenna. Keep the antenna away from the speaker cords and the power cord to avoid picking up noise. With a DAB external antenna (not supplied), you can obtain higher DAB broadcast sound quality. We recommend that you use the supplied FM/DAB lead antenna only temporarily until you install a DAB external antenna. Before unplugging the DAB antenna, make sure the system is turned off to preserve your own DAB settings. ) or Connect brown side or Connect white side Connect the power cord to a wall socket. If the plug does not fit the wall socket, detach the supplied plug adaptor (only for models equipped with an adaptor). Press TAPE (eject) on the unit, and load a TYPE I (normal) tape into the cassette holder with the side you want to play facing forward. Immediately unplug the power cord, and check the following item. If your system has a voltage selector, is the voltage selector set to the correct voltage? are the + and speaker cords short-circuited?Are you using only the supplied speakers? is anything blocking the ventilation holes on the rear of the system?After the STANDBY indicator stops flashing, reconnect the power cord, and turn on the system. With CD player power turned off, disc access time is increased. To turn on CD player power, repeat the procedure until "CD POWER ON" appears. The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall socket, even if the unit itself has been turned off. Completely disconnect the power cord (mains lead) from the wall socket (mains) if it is not going to be used for an extended period of time. When unplugging the unit, always grip the plug. [. . . ] You cannot eject the disc during CD Synchro Recording. If you stop the CD Synchro Recording by pressing CD (stop) , the tape stops after making about a 4 seconds blank (unrecorded) space before stopping. When you record on both sides, be sure to start from the front side. If you start from the reverse side, recording stops at the end of the reverse side. [. . . ]