User manual SONY CMT-DC1

[. . . ] Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. The following caution label is located inside the apparatus. US and foreign patents licensed from Dolby Laboratories. Don't throw away the battery with general house waste, dispose of it correctly as chemical waste. [. . . ] "Tr Protect" appears when the track was recorded or edited on another deck and then protected. You cannot erase tracks on this deck when "Tr Protect" appears. If you erase all the tracks within a group, the group is also erased at the same time as all the tracks within that group. You can erase the disc title, group titles, all recorded tracks and their titles at once. The remote) repeatedly until the desired track number appears, then press ENTER/YES on the remote. " appear alternately while the deck plays the selected track from the beginning to point A. If you perform the above operations when the Group Function is on, not only the tracks within the group, but all the tracks on the MD will be erased. You can use this function to change the order of any track on the disc. When you move tracks, the tracks are automatically renumbered. You can shift the starting point by 1/86 second (1 frame) intervals*. To shift the point by second or minute intervals, press m or M so that second or minute flashes, then press l or L (or . Second track number to be continued New track number " does not appear when there is no editing function that can be cancelled. When you combine two tracks that are registered into different groups, the second track is re-registered into the group containing the first track. In addition, if you combine a track that is registered to a group with a track that is not registered to a group, the second track takes the same registration setting as the first track. However, when the Group Function is on, you can only combine tracks within the selected group. Tracks recorded in different recording modes (stereo, LP2, LP4 or MONO) cannot be combined. If both of the combined tracks have track titles, the title of the second track is erased. You can change the volume of recorded tracks using S. The original track is recorded over at the new recording level. When changing the recording level, you can select Fade-in Recording to gradually increase the signal level at the start of recording, or Fade-out Recording to gradually decrease the signal level at the end of the recording. The recording level can be changed from ­12 dB to +12 dB, in 2 dB steps. Change to the optimum level while making sure that "OVER" does not appear in the display at the loudest portion. [. . . ] The MD is dirty or scratched, or the MD does not meet the standards. CRemove the MD once, then insert it again. There is no disc in the MD deck, or the MD is protected against erasure. You tried to programme 26 or more tracks (steps). [. . . ]