User manual SONY CMT-EH20DAB

[. . . ] Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) If your country or region does not support DAB broadcast, "NO SERV" appears. ⷠDo not press any button on the unit or the remote during DAB Automatic Scan. Scanning is interrupted and service list may not be created properly. In this case, run the DAB Automatic Scan again. [. . . ] ⷠ"REP1" indicates that a single track or file is repeated until you stop it. For example, you can view: ­ CD/MP3 disc information such as the track or file number, folder name (during normal play), or the total play time (while the player is stopped) ­ DAB station information such as the service name, channel label, DLS (Dynamic Label Segment), or ensemble label 2) The STANDBY indicator lights up when the system is turned off. Connect the power cord to a wall socket. If the plug does not fit the wall socket, detach the supplied plug adaptor (only for models equipped with an adaptor). When scanning is complete, a list of available services is created. Use buttons on the remote to create your own program. You can record just the portions you like from a sound source, including connected audio components. Use buttons on the unit to control tape recording. FULL : You tried to program more than 15 tracks (steps). NO DISC : There is no disc in the player, or you have loaded a disc that cannot be played. OVER : You have reached the end of the disc while pressing during playback or pause. PUSH SELECT : You tried to set the clock or timer during timer operation. pUSH STOP : You pressed PLAY MODE during playback. READING : The system is reading information from the disc. SET CLOCK : You tried to select the timer when the clock is not set. SET TIMER : You tried to select the timer when the Play Timer is not set. The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall socket, even if the unit itself has been turned off. ⷠCompletely disconnect the power cord (mains lead) from the wall socket (mains) if it is not going to be used for an extended period of time. When unplugging the unit, always grip the plug. Should any solid object or liquid get into the system, unplug the system, and have it checked by qualified personnel before operating it again. ⷠThe AC power cord can be changed only by a qualified service facility. 1 Make sure the power cord and speaker cords are 2 Find your problem in the checklist below, and take While the player is stopped. [. . . ] The use of the tape with more than 90 minutes of play time is not recommended except for long, continuous recording or playback. MODE repeatedly until "PRESET" appears, and then press +/­ (or TUNING + or ­ on the unit) repeatedly to select the desired preset number. Severe hum or noise, or stations cannot be received. Find a location and an orientation that provide good reception, and then set up the antenna again. [. . . ]