User manual SONY CMT-FX300I annexe 2

[. . . ] Unit Getting Started Listening to the radio 1 Select "TUNER FM" or "TUNER AM. " Press FUNCTION +/ repeatedly. Notes 2 Perform tuning. For automatic scanning Press TUNING MODE repeatedly until "AUTO" appears, and then press + / . Scanning stops automatically when a station is tuned in, and "TUNED" and "ST" (for stereo programs only) light up in the display. When placing or removing the iPod, handle the iPod in the same angle as that of the iPod connector on the unit and do not twist or sway the iPod to prevent connector damage. Do not carry the unit with an iPod set on the connector. When placing or removing the iPod, brace the unit with one hand and take care not to press the controls of the iPod by mistake. [. . . ] To turn on the function, repeat the procedure until "AUTO. STBY ON" appears. Notes AUTO STANDBY" lights up in the display when the automatic " standby function is turned on. e automatic standby function is invalid for the tuner functions Th (FM/AM), even when "AUTO STANDBY" lights up in the display. e system may not enter standby mode automatically in the Th following cases; when an audio signal is detected. when an iPod or USB device is connected. during playback of audio tracks or files. while the preset Play Timer or Sleep Timer is in process. 3 Select the AUDIO IN function. Press FUNCTION +/ repeatedly. 6 Select the sound source. Press / repeatedly until the desired sound . source appears, then press Erroneous display Completely disconnect the power cord (mains lead) from the wall outlet (mains) if it is not going to be used for an extended period of time. When unplugging the unit, always grip the plug. Should any solid object or liquid get into the system, unplug the system, and have it checked by qualified personnel before operating it again. The AC power cord can be changed only by a qualified service facility. Compatible iPod models: 4 Start playback. Start playback of the connected component and adjust the volume. Note The system may enter standby mode automatically if the volume level of the connected component is too low. Adjust the component's volume accordingly. See "To turn off the automatic standby function. " 7 Turn off the system. Press . The system turns on 15 seconds before the preset time. If the system is on at the preset time, the Play Timer will not play. Do not operate the system from the time the system turns on until the playback starts. Send the music data to the USB device again, as the data stored in the USB device may have been corrupted. The character codes that can be displayed by this system are numbers and alphabets only. Other characters are not displayed correctly. iPod nano 5th generation (video camera) On placement Play does not start from the first track. The USB device is not recognized. To check the setting Return to Normal Play by pressing PLAY MODE repeatedly until both "PGM" and "SHUF" disappear. Adjusting the sound To Adjust the volume Generate a more dynamic sound (Dynamic Sound Generator X-tra) Set the sound effect Press VOLUME +/ . DSGX on the unit. 1 Press TIMER MENU . 2 Press / repeatedly to select "SELECT, " and then press . Starting playback takes more time than usual. 3 Press / repeatedly to select "PLAY SEL, " and then press . To cancel the timer EQ . Repeat the same procedure as above until "OFF" appears . in step 3, and then press The following discs can increase the time it takes to start playback; a disc recorded with a complicated tree structure. a disc that has not been finalized (a disc to which data can be added). [. . . ] The specified station may have temporarily stopped broadcast. "OVER CURRENT" appears. You can wake up to CD, FM/AM reception, iPod or USB device at a preset time. Make sure you have set the clock. Sound comes from one channel, or the left and right volumes are unbalanced. Place the speakers as symmetrically as possible. Connect only the supplied speakers. A problem has been detected with the level of electrical current from the (USB) port . Turn off the system and remove the USB device from the (USB) port . [. . . ]