User manual SONY CMT-HPR99XM

[. . . ] WARNING 2-668-125-11(1) Note on DualDiscs A DualDisc is a two sided disc product which mates DVD recorded material on one side with digital audio material on the other side. However, since the audio material side does not conform to the Compact Disc (CD) standard, playback on this product is not guaranteed. Micro HI-FI Component System Operating Instructions Owner's Record The model and serial numbers are located on the rear of the unit. Record these numbers in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. [. . . ] 2 Press PLAY MODE repeatedly until "PGM" appears while the player is stopped. Sleep Timer: You can fall asleep to music. This function works even if the clock is not set. If you select "AUTO, " the system automatically turns off after the current disc stops or in 100 minutes. take the indicated corrective action. If the issue persists, contact your nearest Sony dealer. 2 While holding down , press If the STANDBY indicator flashes 3 Press DISC SKIP to select a disc. 4 Press / repeatedly or turn the jog dial on the unit until the desired track number appears. When programming "ATRAC" files or MP3 files, press +/­ (select folder) repeatedly or turn the jog dial on the unit to select the desired folder, and then select the desired file. Current disc Selected track or file number Total playing time of program (including selected track or file) Play Timer: You can wake up to CD or tuner at a preset time. Use buttons on the remote to control the Play Timer. Make sure you have set the clock. 1 Prepare the sound source. Prepare the sound source, and then press VOLUME +/­ to adjust the volume. To start from a specific CD track, "ATRAC" file or MP3 file, create your own CD program. Immediately unplug the power cord, and check the following item. · If your system has a voltage selector, is the voltage selector set to the correct voltage?· Are you using only the supplied speakers?· Is anything blocking the ventilation holes on the rear of the system?After the STANDBY indicator stops flashing, reconnect the power cord, and turn on the system. If the issue persists, contact your nearest Sony dealer. (power) . To reset the interval to the factory preset, repeat the procedure. You cannot change the AM tuning interval in Power Saving Mode. Specifications Main unit AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: With 4 ohm loads, both channels driven, from 120 ­ 10, 000 Hz; rated 85 watts per channel minimum RMS power, with no more than 10% total harmonic distortion from 250 milliwatts to rated output. To improve tuner reception Turn off CD player power by using the CD power management function. You cannot change the setting in Power Saving Mode. Use buttons on the unit to turn off CD player power. Amplifier section 1 Press CD/ (play/pause) to select the CD function. 2 Press (power) to turn off the system. 3 After "STANDBY" stops flashing, press General The display starts flashing as soon as you plug in the power cord even though you have not turned on the system. 2 Press CLOCK/TIMER SET . 3 Press / repeatedly to select "PLAY Loaded disc (power) while holding ENTER . "CD POWER" and "OFF" appear. With CD player power turned off, disc access time is increased. [. . . ] OFF AIR : The channel is not broadcasted now. UPDATING : You have not subscribed for XM or the channel is not authorized. ­ ­ ­ : There is no text information or time information in the channel. The text information may not be displayed depending on the system condition, for example, right after the system has received a channel. Preset number Tuner Severe hum or noise, or stations cannot be received. · Connect the antenna properly. [. . . ]