User manual SONY CMT-J3MD

[. . . ] Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. The following caution label is located inside the unit. This system is equipped with the Dolby* B-type noise reduction system. * Dolby noise reduction manufactured under license from Dolby Laboratories Licensing Corporation. [. . . ] You can input a total of approximately 1700 characters for the disc title and track titles on a single MD. "TOC" lights up, or either "TOC" or "STANDBY" starts flashing. Before pulling out the mains lead Do not pull out the mains lead before updating the TOC (while "TOC" is lit) or while updating the TOC (while "TOC" or "STANDBY" is flashing) to ensure a complete editing. Or > repeatedly until the desired track number appears. Repeat steps 3 to 5 to complete the entire title. If you made a mistake Press CURSORT or t until the character you want to change flashes, then repeat steps 3 to 5. Press CLEAR while the character is flashing. Each time you press the button, the display changes as follows: A (Upper cases) t a (Lower cases) t 0 (Number) t !The titles you labelled appear sequentially, and then the original display appears. You can label a track title during play. If the MD is record protected, "C11" and "Protected" appear alternately and the MD cannot be edited. Remove the MD, then slide the record protection tab to the closed position (see page 32). To enter a blank space You cannot enter a space as the first character. You can copy a labelled disc or track title to use it as a title of another track or the disc title within a disc. Or > repeatedly to select "Disc" (when copying the disc title) or the track number with the title you want to copy, then press ENTER/YES. When "No Name" appears The disc or track has not been labelled. Or > repeatedly to select the copy destination track number or "Disc" (when copying as the disc title), then press ENTER/ YES. " appears The copy destination already has a disc or track title. The character you selected in step 4 stops flashing and the cursor shifts to the right. The MD deck lets you erase unwanted tracks quickly and easily. You can restore the contents to the condition before erasing (unerase) by using the Undo function. Note, however, you cannot undo an edit after performing any additional edits. [. . . ] C12/CannotCopy You tried to record a CD or MD with a format that the system does not support, such as a CDROM. CRemove the disc and turn off the system once, then turn it on again. The MD is dirty or scratched, or the MD does not meet the standards. CRemove the MD once, then insert it again. [. . . ]