User manual SONY CMT-MD1

[. . . ] The model and serial numbers are located on the bottom. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] The MD recording is complete only after all the recording information is entered to TOC at which point TOC stops flashing and goes out. Be careful not to disconnect the power cord or move the system before this point. Before disconnecting the power cord, do the following: ­ Remove the MD. Making a space between tracks 3 seconds long â­Â­ Smart Space , Auto Cut The Smart Space and Auto Cut functions let you make a blank space between tracks three seconds long automatically while making a digital recording. If there is extended silence of 4 to 29 seconds while digital recording, the system replaces the silence with a blank of about 3 seconds and continues recording. If there is no sound input for 30 seconds while digital recording, the system replaces the silence of 30 seconds with a blank of about 3 seconds and enters recording pause. If you turn the power off or disconnect the power cord, the system will recall the last setting (ON or OFF) of the Smart Space and Auto Cut functions the next time you turn the power on. â· The MD recording is complete only after all the recording information is entered to TOC at which point TOC stops flashing and goes out. Be careful not to disconnect the power cord or move the system before this point. Before disconnecting the power cord, do the following: ­ Remove the MD. Marking track numbers at a specific point while recording â­Â­ Track Mark You can mark track numbers at any time while recording, regardless of the type of sound source. Press REC while recording at the point you want to add a track mark. The tracks following the added one are numbered. Press EDIT, then press +/­ on the remote repeatedly until "S. By using the editing functions, you can create a new sequence to the recorded MD. Before editing, check the conditions by following the procedure below. You can use upper case, numbers and symbols for the titles. â· Erase ­ Erasing recordings Use this function to erase a single track one by one or all tracks at once. â· Move ­ Changing the order of tracks Use this function to change the track numbering. â· Divide ­ Adding track numbers Use this function to add track numbers. This lets you locate your favorite phrases quickly. â· Combine ­ Combining recorded tracks By using this function, the blank space between two tracks is erased and those two tracks are combined to one track. [. . . ] Impossible You tried to combine from the first track on an MD, which is not possible. You tried to divide the first or end of the track. Level Over A strong signal was input during analog recording in the TAPE function. Name Full There is no more space to store track or disc titles. [. . . ]