User manual SONY CMT-SP55TC

[. . . ] Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. This system is equipped with the Dolby* B-type noise reduction system. Falling asleep to music -- Sleep Timer . Perform the following procedure 1 to 6 to hook up your system using the supplied cords and accessories. [. . . ] If noise is heard while recording an AM radio programme, move the AM loop aerial to reduce the noise or connect a ground wire to the U terminal (see page 36). â· When you record on both sides, be sure to start from the front side. If you start from the reverse side, recording stops at the end of the reverse side. â· Press TUNING MODE repeatedly until "AUTO" appears in step 2, then press m or M. The frequency indication changes and the scanning stops when the system tunes in a station (Automatic Tuning). You can label each preset station with up to 12 characters (Station Name). Each time you press the button, the display changes as follows: A (Upper cases) t a (Lower cases) t 0 (Numbers) t !To enter a blank space Go to step 7 without pressing . You cannot enter a space as the first character. The character you selected in step 6 stops flashing and the cursor shifts to the right. Repeat steps 5 to 7 to complete the entire title. If you made a mistake Press CURSORT or t until the character you want to change flashes, then repeat steps 5 to 7. RDS may not work properly if the station you are tuned in is not transmitting the RDS signal properly or if the signal is weak. * Not all FM stations provide RDS service, nor do they provide the same types of services. If you are not familiar with the RDS system, check with your local radio stations for details on RDS services in your area. Press CURSORT or t until the character you want to erase flashes, then press CLEAR. Each time you press the button, the display changes as follows: t Station name* r The preset number and the frequency r Clock display * When the station is not labelled, the preset number and the frequency are displayed automatically. Do steps 1 to 4 and press CLEAR repeatedly until the label disappears, then press ENTER/YES. Each time you press DISPLAY, the display changes as follows: t Station name* r Frequency r Clock display * If the RDS broadcast is not received, the station name may not appear in the display. Falling asleep to music -- Sleep Timer You can set the system to turn off after a certain time, so that you can fall asleep to music. You can preset the time to turn off in 10 minutes increments. You can use Sleep Timer, even if you have not set the clock. [. . . ] The tape does not record or play, or there is a decrease in sound level. There is excessive wow or flutter, or the sound drops out. Noise increases or the high frequencies are erased. Find a place and an orientation that provide good reception, then set up the aerial again. [. . . ]