User manual SONY CMT-SPZ50

[. . . ] Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. the recycling of materials will help to conserve natural resources. [. . . ] 1 Make sure the power cord and speaker cords are 2 Find your problem in the checklist below, and With CD player power turned off, disc access time is increased. To turn on CD player power, repeat the procedure until "CD POWER" and "ON" appear. You can record an entire CD onto a tape. You can record just the portions you like from a sound source, including connected audio components. Use buttons on the unit to control tape recording. The system turns on 15 seconds before the preset time. Dial on the unit until the desired track number appears. When programming MP3 files, press +/­ (select folder) repeatedly or turn the jog dial on the unit to select the desired folder, and then select the desired file. Current disc Selected track Total playing time of program or file number (including selected track or file) 1 Load a recordable tape with the side you want to Load the disc you want to record. When recording a folder from an MP3 disc, press PLAY MODE repeatedly to select " , " and then press +/­ (select folder) repeatedly to select the desired folder. To record only your favorite CD tracks in your desired order, perform steps 2 through 6 of "Creating your own CD program. Press CLOCK/TIMER SELECT , press / repeatedly until "PLAY SEL" or "REC SEL" appears, and then press ENTER . Immediately unplug the power cord, and check the following item. ⷠIf your system has a voltage selector, is the voltage selector set to the correct voltage? ⷠAre you using only the supplied speakers?After the STANDBY indicator stops flashing, reconnect the power cord, and turn on the system. If the system still does not operate properly, reset the system to factory settings. You cannot reset the system to factory settings in Power Saving Mode. Use buttons on the unit to reset the unit to its factory default settings. Be careful when placing the unit or speakers on surfaces that have been specially treated (for example, with wax, oil, polish) as staining or discoloration of the surface may result. ⷠIf the system is brought directly from a cold to a warm location or is placed in a very damp room, moisture may condense on the lens inside the CD player, and cause the system to malfunction. In this situation, remove the disc, and leave the system turned on for about a few hours until the moisture evaporates. [. . . ] The preset stations are retained for about half a day even if you disconnect the power cord or if a power failure occurs. You can record a preset radio station at a specified time. use buttons on the remote to control the Play Timer and the Rec Timer. Before playing, wipe the disc with a cleaning cloth from the center out to the edge. [. . . ]