User manual SONY CMT-SPZ55

[. . . ] 2-668-123-14(1) Micro HI-FI Component System Operating Instructions GB Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) Basic Operations This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The recycling of materials will help to conserve natural resources. [. . . ] If the issue persists, contact your nearest Sony dealer. If the system still does not operate properly, reset the system to factory settings. You cannot reset the system to factory settings in Power Saving Mode. Use buttons on the unit to reset the unit to its factory default settings. · Be careful when placing the unit or speakers on surfaces that have been specially treated (for example, with wax, oil, polish) as staining or discoloration of the surface may result. · If the system is brought directly from a cold to a warm location or is placed in a very damp room, moisture may condense on the lens inside the CD player, and cause the system to malfunction. In this situation, remove the disc, and leave the system turned on for about a few hours until the moisture evaporates. AM tuner section: Tuning range European and Russian models: 531 ­ 1, 602 kHz (with 9 kHz tuning interval) Latin American model: 530 ­ 1, 710 kHz (with 10 kHz tuning interval) 531 ­ 1, 710 kHz (with 9 kHz tuning interval) Other models: 530 ­ 1, 710 kHz (with 10 kHz tuning interval) 531 ­ 1, 602 kHz (with 9 kHz tuning interval) Antenna: AM loop antenna Antenna terminals: External antenna terminal Intermediate frequency: 450 kHz Speaker CMT-SPZ70 Speaker system: 2-way, bass-reflex type Speaker units Woofer: 13 cm dia. , cone type Tweeter: 4 cm dia. , HDLD (High Density Layered Diaphragm) tweeter Nominal impedance: 4 ohms Dimensions (w/h/d): Approx. 163 × 280 × 262 mm Mass: Approx. 2. 7 kg net per speaker CMT-SPZ55/SPZ50 Speaker system: 2-way, bass-reflex type Speaker units Woofer: 12 cm dia. , cone type Tweeter: 4 cm dia. , cone type Nominal impedance: 6 ohms Dimensions (w/h/d): Approx. 163 × 280 × 220 mm Mass: Approx. 2. 3 kg net per speaker On heat buildup · Heat buildup on the unit during operation is normal and is not cause for alarm. · Do not touch the cabinet if it has been used continuously at a high volume because the cabinet may have become hot. · Do not obstruct the ventilation holes. 1 Disconnect and reconnect the power cord, and then turn on the system. 2 Press PLAY MODE/TUNING MODE , DISPLAY and (power) at the same time. All user-configured settings, such as preset radio stations, timer, and the clock, are deleted. On the speaker system This speaker system is not magnetically shielded, and the picture on nearby TV sets may become magnetically distorted. In this situation, turn off the TV, wait 15 to 30 minutes, and turn it back on. If there is no improvement, move the speakers far away from the TV. General To cancel the timer Repeat the same procedure as above until "TIMER OFF" appears, and then press ENTER . General Sound comes from one channel, or the left and right volumes are unbalanced. · Place the speakers as symmetrically as possible. · Connect only the supplied speakers. Messages CANT LOCK : The system cannot be locked after you have done the procedure of "When carrying this system. " Turn the power off and then on again by pressing (power) on the unit, then perform the procedure. CD OVER : You have reached the end of the disc while pressing (fast forward) during playback or pause. COMPLETE : The preset operation ended normally. NO DISC : There is no disc in the player, or you have loaded a disc that cannot be played. NO TAB : You cannot record because the overwrite protection tab has been removed from the cassette. NO TAPE : There is no tape in the tape deck. NOT IN USE : You pressed an invalid button. PUSH SELECT : You tried to set the clock or timer during timer operation. [. . . ] Also, clean and demagnetize the tape heads. See "Precautions" for details. 4 Press ENTER . 5 Repeat steps 1 through 4 to store other stations. You can preset up to 20 FM and 10 AM stations. The preset stations are retained for about half a day even if you disconnect the power cord or if a power failure occurs. Rec Timer: You can record a preset radio station at a specified time. [. . . ]