User manual SONY CPD-120AS

[. . . ] The model and serial numbers are located at the rear of the unit. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] windows® is a registered trademark of Microsoft Corporation in the United States and other countries. Note on recommended horizontal timing conditions Horizontal sync width should be more than 1. Horizontal blanking width should be more than 3. When using a video mode that is not one of the 10 factory preset modes, some fine tuning may be required to optimize the display to your preferences. Simply adjust the display according to the adjustment instructions. With the tilt-swivel, this unit can be adjusted to be viewed at your desired angle within 90° horizontally and 7° vertically. To turn the unit vertically and horizontally, hold it at its bottom with both hands. Pay attention not to get your hands caught between the display and the tilt-swivel. Using a white background, very thin horizontal lines on the screen are visible as shown below. the Trinitron tube has a vertically striped Aperture Grille inside. The Aperture Grille allows more light to pass through to the screen giving the Trinitron CRT more color and brightness. When one of the preset-type signals is input, no picture adjustment is necessary. You can, however, adjust the picture to your preference by following the procedure described below. The horizontal and vertical frequencies for each input signal received appear. The VOLUME/CONTRAST OSD disappears 3 seconds after you release the buttons. On the VOLUME/CONTRAST OSD while the sound is muted. The horizontal and vertical frequencies for each input signal received appear. + for more contrast ­ for less contrast The VOLUME/CONTRAST OSD disappears 3 seconds after you release the buttons. + for more brightness ­ for less brightness Tip If you don't touch any buttons the OSD automatically disappears after 10 seconds. When you want to adjust another item, press the button of the item. + to move up ­ to move down + to move right ­ to move left Tip If you don't touch any buttons, the OSD automatically disappears after 10 seconds. When you want to adjust another item, press the button of the item. [. . . ] Note 1) To lower the power consumption to 0 W, disconnect the power cord. 22 kg (48 lb 8 oz) Design and specifications are subject to change without notice. This section may help you isolate a problem and as a result, eliminate the need to contact technical support, allowing continued productivity. No picture If the u indicator is not lit m Check that the power cord is properly connected. [. . . ]