User manual SONY CPD-15SF2T

[. . . ] Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. [. . . ] If necessary, adjust the user controls according to your personal preference. When one of the preset-type signals is input, no picture adjustment is necessary. You can, however, adjust the picture to your preferences by following the procedure described below. Before adjusting the items, turn on the unit and feed the video signal from the connected computer/work station. The "CONTRAST/BRIGHTNESS" OSD disappears 2 seconds after you release the buttons. The "CENTER" OSD automatically disappears 20 seconds after you release the buttons. The "CONTRAST/BRIGHTNESS" OSD disappears 2 seconds after you release the buttons. The "GEOMETRY" OSD automatically disappears 20 seconds after you release the buttons. The "SIZE" OSD automatically disappears 20 seconds after you release the buttons. The "GEOMETRY" OSD automatically disappears 20 seconds after you release the buttons. When using a video mode that is not one of the 6 factory preset modes, some fine tuning may be required to optimize the display to your preferences. Simply adjust the monitor according to the preceding adjustment instructions. This monitor meets the power saving guidelines set by the EPA Energy Star Program as well as the more stringent TCO92 803299 (NUTEK) guidelines. It is capable of reduced power consumption when used with a computer equipped with Display Power Management Signaling (DPMS). By sensing the absence of the sync signal coming from the computer, it will reduce the power consumption as follows: CAUTION: The Power Saving function will automatically put the monitor into Active-off state if the power switch is turned on without any video signal input. Once the horizontal and vertical syncs are sensed, the monitor will automatically return to its Normal operation state. Green on off The "COLOR TEMPERATURE" OSD automatically disappears 20 seconds after you release the buttons. 10% (1st step of power saving) CPD-15SF2T: Active-off approx. 7% (2nd step of CPD-17SF2T: power saving) approx. Press the RESET button to recall the factory settings for brightness, contrast, horizontal and vertical size, center and pincushion for the mode currently in use. Press and hold the RESET button for 2 seconds to recall factory setting for all adjustments in all modes. This monitor complies with the DDC1TM* and DDC2BTM* which are the Display Data Channel (DDC) standards of VESA. [. . . ] a fine horizontal line (wire) is visible / This wire stabilizes the vertically striped Aperture Grille. This Aperture Grille allows more light to pass through to the screen giving the Trinitron CRT more color and brightness. Wavy or elliptical (moire) pattern is visible / Due to the relationship between resolution, monitor dot pitch and the pitch of some image patterns, certain screen backgrounds, especially gray, sometimes show moire. This can only be eliminated by changing your desktop pattern. [. . . ]