User manual SONY CPD-15SX1

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Before using your monitor, check that the following accessories are included in your carton: · You will need a Macintosh adapter (not supplied). Step 1: Connect your monitor to your computer Turn off the monitor and computer before connecting. Note Do not touch the pins of the video cable connector as this might bend the pins. Step 2: Connect the power cord With the monitor and computer switched off, first connect the power cord to the monitor, then connect it to a power outlet. First turn on the monitor, then turn on the computer. English, French, German, Italian, Spanish, Russian and Japanese versions of the on-screen menus are available. If necessary, use the monitor's controls to adjust the picture. See page 9 for more information on using the control button. If no picture appears on your screen If NO INPUT SIGNAL appears on the screen, confirm that your computer's graphic board is completely seated in the correct bus slot. If you are replacing an old monitor with this model and OUT OF SCAN RANGE appears on the screen, reconnect the old monitor. Then adjust the computer's graphic board so that the horizontal frequency is between 30 ­ 70 kHz, and the vertical frequency is between 48 ­ 120 Hz. Select PIN PIN BALANCE To expand or contract the picture sides shift the picture sides to the left or right Then move the control button </, to make the adjustment. Adjusting the vertical size or centering of the picture (V-SIZE/ CENTER) These settings are stored in memory for the current input signal. These settings are stored in memory for the current input signal. Then move the control button </, to make the adjustment. Select KEY KEY BALANCE To adjust the picture width at the top of the screen shift the picture to the left or right at the top of the screen Then move the control button </, to make the adjustment. This setting is stored in memory for all input signals. The COLOR settings allow you to adjust the picture's color temperature by changing the color level of the white color field. This setting is stored in memory for all input signals. This setting is stored in memory for the current input signal. Since the default setting is 9300K, the whites will change from a bluish hue to a reddish hue as the temperature is lowered to 6500K and 5000K. Then move the control button m/M to select R (red), G (green), or B (blue) and move </, to make the adjustment. [. . . ] For Windows users, check your video board manual or the utility program which comes with your graphic board and select the highest available refresh rate to maximize monitor performance. If no signal is received by the monitor from the connected computer, the monitor will automatically reduce power consumption as shown below. If there is something wrong with the input signal, one of the following messages appears on the screen. Green orange** off When your computer enters the "active off" mode, the input signal is cut and NO INPUT SIGNAL appears on the screen. [. . . ]