User manual SONY CPD-200EST

[. . . ] The model and serial numbers are located at the rear of the unit. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] The "CENTER" OSD automatically disappears 10 seconds after you release the buttons. For more brightness The horizontal and vertical frequencies for each input signal received appear on the "BRIGHTNESS/CONTRAST" OSD. The "BRIGHTNESS/CONTRAST" OSD disappears approximately 3 seconds after you release the buttons. The "GEOMETRY" OSD automatically disappears 10 seconds after you release the buttons. The "SIZE" OSD automatically disappears 10 seconds after you release the buttons. The "GEOMETRY" OSD automatically disappears 10 seconds after you release the buttons. Press the button of the adjustment item you want to reset, and then press the RESET button before the OSD (On Screen Display) disappears. To reset all adjustment data at once (for the received signal) If you have difficulties pressing the reset button, please use a pointed object (e. The "COLOR TEMPERATURE" OSD automatically disappears 10 seconds after you release the buttons. When using a video mode that is not one of the factory preset modes, some fine tuning may be required to optimize the display to your preferences. Simply adjust the monitor according to the preceding adjustment instructions. This monitor complies with DDCTM1 and DDC2B, which are the Display Data Channel (DDC) standards of VESA. When a DDC1 host system is connected, the monitor synchronizes with the V. This monitor meets the power saving guidelines set by the International ENERGY STAR Program as well as the more stringent NUTEK guidelines. It is capable of reduced power consumption when used with a computer equipped with Display Power Management Signaling (DPMS). By sensing the absence of the sync signal coming from the computer, it will reduce the power consumption as follows: CAUTION: The Power Saving function will automatically put the monitor into Active-off state if the power switch is turned on without any video signal input. Once the horizontal and vertical syncs are sensed, the monitor will automatically return to its Normal operation state. With the tilt-swivel, this unit can be adjusted to be viewed at your desired angle within 180° horizontally and 20° vertically. To turn the unit vertically and horizontally, hold it at its bottom with both hands. State Normal operation Standby (1st step of power saving) Suspend (2nd step of power saving) Active-off (3rd step of power saving) Power-off U POWER indicator green on Orange and green flashes alternately Orange and green flashes alternately Orange on off Using a white background, very thin horizontal stripes on the screen are visible as shown on the illustration. These wires are attached to the aperture grille inside the Trinitron tube and are there to dampen vibrations of the aperture grille in order to prevent them from influencing the picture quality. Design and specifications are subject to change without notice. [. . . ] The requirements cover a wide range of issues: environment, ergonomics, usability, emission of electrical and magnetic fields, energy consumption and electrical and fire safety. The environmental demands concern restrictions on the presence and use of heavy metals, brominated and chlorinated flame retardants, CFCs (freons) and chlorinated solvents, among other things. The product must be prepared for recycling and the manufacturer is obliged to have an environmental plan which must be adhered to in each country where the company implements its operational policy. The energy requirements include a demand that the computer and/or display, after a certain period of inactivity, shall reduce its power consumption to a lower level in one or more stages. [. . . ]