User manual SONY CPD-200SF

[. . . ] Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. [. . . ] 9 pin) adapter (not supplied) for any current DOS computer which is not compatible with DDC 2 AB and its No. Macintosh II series and some older version of PowerBook models may need an adapter with micro switches. Step 2: Attach the power cord to the monitor and the other end to a power outlet. For the customers using the Windows®4)95 Install the new model information of the Sony computer display Power cord (supplied) to a power outlet This monitor complies with "VESA DDC, " the standards of Plug&Play. If your PC/graphic board complies with DDC, select "Plug and Play Monitor (VESA DDC)" or this monitor's model name (CPD-100SF or CPD-200SF) as "Monitor type" from "Control Panel" on Windows95. Some PC/graphic boards do not comply with DDC. Even if they comply with DDC, they may have some problems on connecting this monitor. In this case, select this monitor's model name (CPD-100SF or CPD-200SF) as "Monitor type" on Windows95. From "Windows95 Monitor Information Disk" into your PC. If necessary, adjust the user controls according to your personal preference. When one of the preset-type signals is input, no picture adjustment is necessary. You can, however, adjust the picture to your preferences by following the procedure described below. Before adjusting the items, turn on the unit and feed the video signal from the connected computer/work station. The "CONTRAST/BRIGHTNESS" OSD disappears 3 seconds after you release the buttons. The "CENTER" OSD automatically disappears 10 seconds after you release the buttons. For less contrast The horizontal and vertical frequencies for each input signal received appear on the "CONTRAST/BRIGHTNESS" OSD. The "CONTRAST/BRIGHTNESS" OSD disappears 3 seconds after you release the buttons. The "GEOMETRY" OSD automatically disappears 10 seconds after you release the buttons. The "SIZE" OSD automatically disappears 10 seconds after you release the buttons. The "GEOMETRY" OSD automatically disappears 10 seconds after you release the buttons. Press the button of the adjustment item you want to reset, and then press the RESET button before the OSD (On Screen Display) disappears. To reset all adjustment data at once (for the received signal) Press the RESET button with something like a pen for 1 second when no OSD is shown. [. . . ] Color is not uniform / If the monitor is close to any potential sources of magnetic fields such as a speaker, or you turn the monitor while the u POWER switch is in the "ON" position, color may not be uniform. Trip the u POWER switch once to activate the Autodegauss cycle*. Picture is flickering / If the refresh rate is not appropriate, the picture may flicker. set the refresh rate of the non-interlace mode as high as possible on the computer. [. . . ]