User manual SONY CPD-200SFT

[. . . ] Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. [. . . ] 9 pin in the video signal connector for DDC2AB and DDC2B+ compatibility. Some PC systems which are not compatible with either DDC2AB or DDC2B+ may not accept the No. If you are not sure whether your PC system accepts the No. 9 pin or not, use the HD15 (Female) - HD15 (Male without the No. Step 2: With the monitor switched off, attach the power cord to the monitor and the other end to a power outlet. For the customers using the Windows ® 4) 95 Install the new model information of the Sony computer display from "Windows 95 Monitor Information Disk" into your PC. (To install the file , refer to the attached "About the Windows 95 Monitor Information Disk/File"). This monitor complies with "VESA DDC, " the standards of Plug&Play. If your PC/graphic board complies with DDC, select "Plug and Play Monitor (VESA DDC)" or this monitor's model name (CPD-100SFT or CPD-200SFT) as "Monitor type" from "Control Panel" on Windows 95. Some PC/graphic boards do not comply with DDC. Even if they comply with DDC, they may have some problems on connecting this monitor. In this case, select this monitor's model name (CPD-100SFT or CPD-200SFT) as "Monitor type" on Windows 95. Power cord (supplied) to a power outlet If necessary, adjust the user controls according to your personal preference. When one of the preset-type signals is input, no picture adjustment is necessary. You can, however, adjust the picture to your preferences by following the procedure described below. Before adjusting the items, turn on the unit and feed the video signal from the connected computer/work station. The "CONTRAST/BRIGHTNESS" OSD disappears 3 seconds after you release the buttons. The "CENTER" OSD automatically disappears 10 seconds after you release the buttons. For less contrast The horizontal and vertical frequencies for each input signal received appear on the "CONTRAST/BRIGHTNESS" OSD. The "CONTRAST/BRIGHTNESS" OSD disappears 3 seconds after you release the buttons. The "GEOMETRY" OSD automatically disappears 10 seconds after you release the buttons. The "SIZE" OSD automatically disappears 10 seconds after you release the buttons. [. . . ] Wavy or elliptical (moire) pattern is visible / Due to the relationship between resolution, monitor AG pitch and the pitch of some image patterns, certain screen backgrounds, especially gray, sometimes show moire. This can only be eliminated by changing your desktop pattern. Just after turning the monitor on, a "boon" noise is heard / Just after turning the monitor on, a noise may be heard for about 3 seconds. This noise is not failure, it is caused by the autodegauss cycle. [. . . ]