User manual SONY CPD-20SF2T5

[. . . ] Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. [. . . ] Power cord (supplied) to a power outlet With the computer switched off, attach the video signal cable to the video output. Note: For Windows® 4) users, check your video board manual or the utility program which comes with your graphic board and select the highest available refresh rate to maximize monitor performance. If necessary, adjust the user controls according to your personal preference. 9 pin) adaptor (supplied) for current DOS computer which has no compliance of DDC 2AB and its No. When one of the preset-type signals is input, no picture adjustment is necessary. You can, however, adjust the picture to your preferences by the following procedure described below. Before adjusting the items, turn on the unit and feed the video signal from the connected computer/work station. The "CONTRAST/BRIGHTNESS" OSD disappears 3 seconds after you release the buttons. To move down For horizontal picture adjustment Press the ¨ ?The "CENTER" OSD automatically disappears 10 seconds after you release the buttons. The "CONTRAST/BRIGHTNESS" OSD disappears 3 seconds after you release the buttons. The "GEOMETRY" OSD automatically disappears 10 seconds after you release the buttons. The "SIZE" OSD automatically disappears 10 seconds after you release the buttons. The "GEOMETRY" OSD automatically disappears 10 seconds after you release the buttons. To move Red down and Blue up For horizontal adjustment Press the ¨ ?To move Red to the right and Blue to the left / . To move Red to the left and Blue to the right To erase the "CONVERGENCE" OSD, press the CONV button again. The "CONVERGENCE" OSD automatically disappears 10 seconds after you release the buttons. The "COLOR TEMPERATURE" OSD automatically disappears 10 seconds after you release the buttons. Press the button of the adjustment item you want to reset, and then press the RESET button before the OSD (On Screen Display) disappears. When using a video mode that is not one of the 10 factory preset modes, some fine tuning may be required to optimize the display to your preferences. Simply adjust the monitor according to the preceding adjustment instructions. [. . . ] There is no single answer to solve the problem. There is a tendency to have this problem on higher refresh timings and Macintosh video timings. Edges of the image are curved / Adjust pincushion using the "GEOMETRY" OSD. (page 6) White lines show red or blue shades at edges / Adjust the "CONVERGENCE" on the OSD. [. . . ]