User manual SONY CPD-220GS

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] 0 is different from Windows 95/98 and does not involve the selection of monitor type. 0 instruction manual for further details on adjusting the resolution, refresh rate, and number of colors. To close the menu Press the center of the control button once to return to the main MENU, and twice to return to normal viewing. If no buttons are pressed, the menu closes automatically after about 30 seconds. Adjusting the monitor's resolution and color number Adjust the monitor's resolution and color number by referring to your computer's instruction manual. The color number may vary according to your computer or video board. The color palette setting and the actual number of colors are as follows: · high Color (16 bit) t 65 , 536 colors · True Color (24 bit) t about 16. 77 million colors In true color mode (24 bit), speed may be slower. You can make numerous adjustments to your monitor using the on-screen menu. Press the center of the control button to display the main MENU on your screen. See page 9 for more information on using the control button. If you see red or blue shadows around letters or lines, adjust the convergence. These settings are stored in memory for all input signals. You can manually degauss (demagnetize) the monitor, adjust the moire cancellation level, change the menu position, and lock the controls. To protect adjustment data by locking the controls, first move the control button m/M to select (CONTROL LOCK). If any other items are selected, the mark appears on the screen. To cancel the control lock Repeat the procedure above and set Adjust the selected item according to the following instructions. The monitor is automatically demagnetized (degaussed) when the power is turned on. If a second degauss cycle is needed, allow a minimum interval of 20 minutes for the best result. Then move the control button </, until the moire effect is at a minimum. * Moire is a type of natural interference which produces soft, wavy lines on your screen. It may appear due to interference between the pattern of the picture on the screen and the phosphor pitch pattern of the monitor. [. . . ] Symptom Picture is ghosting Picture is not centered or sized properly Edges of the image are curved Wavy or elliptical pattern (moire) is visible Check that all plugs are firmly seated in their sockets. Note that some video modes do not fill the screen to the edges. If you place equipment that generates a magnetic field, such as a speaker, near the monitor, or if you change the direction the monitor faces, color may lose uniformity. This is the sound of the auto-degauss cycle. [. . . ]