User manual SONY CPD-220VS

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] adjust the CANCEL MOIRE function to eliminate wavy or elliptical patterns that may appear on the screen. Adjust the LANDING function to correct color imbalances at the four corners of the screen due to influence from the earth's magnetism. Once CANCEL MOIRE is adjusted, it will be stored in memory for the current input signal. All other adjustments will be stored in memory for all input signals received. The "5000K, " "6500K" or "9300K" disappears and the new color settings are memorized for each of the three color modes. Select one of the four corners that needs color correction due to influence from the earth's magnetism correct the color at one of the four corners of the screen turn the moire cancellation function "ON" or "OFF. To shift red shadows up and blue shadows down To shift red shadows down and blue shadows up To select the corner of the screen you want to adjust : top left : top right : bottom right : bottom left Moire is a type of natural interference which produces soft or wavy lines on your screen. It may appear due to interference between the regulated pattern of the picture from the input signal and the phosphor pitch pattern of the CRT. The picture may become fuzzy when CANCEL MOIRE is set to "ON. To shift red shadows to the right and blue shadows to the left H CONVERGENCE To shift red shadows to the left and blue shadows to the right To shift red shadows up and blue shadows down To shift red shadows down and blue shadows up To shift red shadows up and blue shadows down To shift red shadows down and blue shadows up The OPTION OSD allows you to manually degauss the screen and adjust settings such as the OSD position and power saving delay time. It also allows you to lock the controls. When viewing a white background, very thin horizontal lines may be visible on the screen as shown below. These lines are the shadows of the damper wires and are characteristic of CRTs that use aperture grilles. The wires are attached to the aperture grille on the inside of the Trinitron tube and prevent the vibration of the aperture grille. If there is something wrong with the input signal, one of the following messages appears. "NO INPUT SIGNAL" indicates that no signal is input, or the input signal from the selected input connector is not received. Indicates which input connector is receiving the wrong signal. If there is something wrong with the signal from both input connectors, "HD15" and "BNC" are displayed alternately. This section may help you isolate the cause of a problem and as a result, eliminate the need to contact technical support. symptom No picture If the u indicator is not lit If the "NO INPUT SIGNAL" message appears on the screen, or if the u indicator is either orange or alternating between green and orange · The screen is blank when the monitor is in power saving mode. Try pressing any key on the computer keyboard. Check that your computer power switch is in the "on" position. [. . . ] It also demands that mercury is not present in any of the electrical or electronics components associated with the labelled unit. CFCs (freons) The relevant TCO'99 requirement states that neither CFCs nor HCFCs may be used during the manufacture and assembly of the product. CFCs (freons) are sometimes used for washing printed circuit boards. CFCs break down ozone and thereby damage the ozone layer in the stratosphere, causing increased reception on earth of ultraviolet light with e. [. . . ]