User manual SONY CPD-300SFT

[. . . ] The model and serial numbers are located at the rear of the unit. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] You can, however, adjust the picture to your preferences by the following procedure described below. Before adjusting the items, turn on the unit and feed the video signal from the connected computer/work station. The "BRIGHTNESS/CONTRAST" OSD disappears 3 seconds after you release the buttons. To move down For horizontal picture adjustment Press the ¨ ?The "CENTER" OSD automatically disappears 10 seconds after you release the buttons. The "BRIGHTNESS/CONTRAST" OSD disappears 3 seconds after you release the buttons. The horizontal and vertical frequencies for each input signal received appear on the "BRIGHTNESS/CONTRAST" OSD. The "GEOMETRY" OSD automatically disappears 10 seconds after you release the buttons. The "SIZE" OSD automatically disappears 10 seconds after you release the buttons. The "GEOMETRY" OSD automatically disappears 10 seconds after you release the buttons. To move Red down and Blue up For horizontal adjustment Press the ¨ ?To move Red to the left and Blue to the right / . To move Red to the right and Blue to the left To erase the "CONVERGENCE" OSD, press the CONV button again. The "CONVERGENCE" OSD automatically disappears 10 seconds after you release the buttons. The OSD automatically disappears 30 seconds after you release the buttons. As the monitor has two sets of input connectors, you can switch between two input video signals. It is necessary to select the connector type (HD15/5 BNC's) correctly according to the connection. Press the button of the adjustment item you want to reset, and then press the RESET button before the OSD (On Screen Display) disappears. To reset the brightness, contrast, size, center, and pincushion at once (for the received signal) Press the RESET button with something like a pen for 1 second when no OSD is shown. When you switch between input sources, the monitor screen is muted for a moment (Mute) then the signal through the selected input is displayed. If the selected input do not receive any video signals, the monitor automatically returns to the other input after Mute and the "COLOR TEMPERATURE/INPUT" selection OSD appears. to erase the "COLOR TEMPERATURE/INPUT" selection OSD , press the COLOR button again. [. . . ] Edges of the image are curved / Adjust pincushion using the OSD. (page 7) White lines show red or blue shades at edges / Adjust the convergence using the OSD. (page 8) Picture is fuzzy / Adjust the contrast and brightness using the OSD (page 6). We have come across several brands of SVGA boards that have an excessive video output level which creates a fuzzy picture at max contrast. [. . . ]