User manual SONY CPD-520GST

[. . . ] Dangerously high voltages are present inside the set. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Although this monitor will sync to other platforms running at horizontal frequencies between 30 and 85 kHz, including Macintosh and Power Macintosh system, a cable adaptor is required. Please consult your dealer for advice on which adaptor is suitable for your needs. Step 1: With the monitor switched off, attach the power cord to the monitor and the other end to a power outlet. The Multiscan 20sfII has factory preset modes for the 10 most popular industry standards for true "plug and play" capability. For less common modes, the Multiscan 20sfII's Digital Multiscan Technology will perform all of the complex adjustments necessary to ensure a high quality picture for any timing between 30 and 85 kHz. However, due to the wide variety of video boards on the market, it may be necessary for the user to fine tune the vertical/horizontal size and centering. Power cord (supplied) to a power outlet With the computer switched off, attach the video signal cable to the video output. Note: For Windows® 4) users, check your video board manual or the utility program which comes with your graphic board and select the highest available refresh rate to maximize monitor performance. If necessary, adjust the user controls according to your personal preference. 9 pin) adaptor (supplied) for current DOS computer which has no compliance of DDC 2AB and its No. When one of the preset-type signals is input, no picture adjustment is necessary. State Normal operation Standby (1st step of power saving) Suspend (2nd step of power saving) Active-off (3rd step of power saving) Power-off This monitor complies with the DDCTM1, DDC2B and DDC2AB which are the Display Data Channel (DDC) standards of VESA. When a DDC1 host system is connected, the monitor synchronizes with the V. cLK in accordance with the VESA standards and outputs the EDID (Extended Display Identification) to the data line. When a DDC2B or DDC2AB host system is connected, the monitor automatically switches to each communication. With the tilt-swivel, this unit can be adjusted to be viewed at your desired angle within 90° horizontally and 20° vertically. To turn the unit vertically and horizontally, hold it at its bottom with both hands. Using a white background, very thin horizontal stripes on the screen are visible as shown on the illustration. These wires are attached to the aperture grille inside the Trinitron tube and are there to damp vibrations of the aperture grille in order to prevent them from influencing to the picture quality. Design and specifications are subject to change without notice. This section may help you isolate a problem and as a result, eliminate the need to contact technical support, allowing continued productivity. No picture / If neither the u (power) indicator nor the POWER SAVING indicator is lit -- Check that the power cord is properly connected. [. . . ] Even within the proper range some video boards may have a sync pulse that is too narrow for the monitor to sync correctly. Color is not uniform / Trip the power switch once to activate the Auto-degauss cycle*. White does not look white / Adjust the "COLOR TEMPERATURE" on the OSD. (page 7) / If your computer is a Macintosh system, check that micro switches are properly set on the Macintosh adapter for your system. [. . . ]