User manual SONY CPD-9000

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] If you are replacing an old monitor with this model and OUT OF SCAN RANGE appears on the screen, reconnect the old monitor. Then adjust the computer's graphic board so that the horizontal frequency is between 30 ­ 70 kHz, and the vertical frequency is between 48 ­ 120 Hz. For more information about the on-screen messages, see "Trouble symptoms and remedies" on page 14. English, French, German, Spanish, and Italian versions of the onscreen menus are available. See page 9 for more information on using the MENU button. For customers using Windows 95/98 To maximize the potential of your monitor, install the new model information file from the supplied Windows Monitor Information Disk onto your PC. This monitor complies with the "VESA DDC" Plug & Play standard. If your PC/graphics board complies with DDC, select "Plug & Play Monitor (VESA DDC)" or this monitor's model name as the monitor type in the "Control Panel" of Windows 95/98. If your PC/graphics board has difficulty communicating with this monitor, load the Windows Monitor Information Disk and select this monitor's model name as the monitor type. See page 9 for more information on using the +/- and ENTER buttons. 0 is different from Windows 95/98 and does not involve the selection of monitor type. To expand or contract the picture sides shift the picture sides to the left or right Adjusting the vertical size or centering of the picture (V-SIZE/ CENTER) These settings are stored in memory for the current input signal. These settings are stored in memory for the current input signal. Then press the +/- buttons to make - the adjustment. Then press the +/- buttons to make - the adjustment. To adjust the picture width at the top of the screen shift the picture to the left or right at the top of the screen This setting is stored in memory for all input signals. The COLOR settings allow you to adjust the picture's color temperature by changing the color level of the white color field. This setting is stored in memory for all input signals. This setting is stored in memory for the current input signal. Since the default setting is 9300K, the whites will change from a bluish hue to a reddish hue as the temperature is lowered to 6500K and 5000K. Then press the ENTER button to select R (red), G (green), or B (blue) and press the +/- buttons to make the adjustment. Note Adjustment stops when either the horizontal or vertical size reaches its maximum or minimum value. [. . . ] After 20 seconds, the monitor enters the power saving mode. Use the self-diagnosis function (page 16) if the following recommendations do not resolve the problem. Symptom No picture If the 1 (power) indicator is not lit · Check that the video signal cable is properly connected and all plugs are firmly seated in their appears on the screen, or if the 1 sockets (page 6). Alternating between green and orange xProblems caused by the connected computer or other equipment · the computer is in power saving mode. [. . . ]