User manual SONY CPD-E100P

[. . . ] The model and serial numbers are located at the rear of the unit. record these numbers in the spaces provided below. Refer to them whenever you call upon your dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] Select PIN PIN BALANCE To expand or contract the picture sides shift the picture sides to the left or right Then move the control button </, to make the adjustment. Adjusting the vertical size or centering of the picture (V-SIZE/ CENTER) These settings are stored in memory for the current input signal. These settings are stored in memory for the current input signal. Then move the control button </, to make the adjustment. Select KEY KEY BALANCE To adjust the picture width at the top of the screen shift the picture to the left or right at the top of the screen Then move the control button </, to make the adjustment. This setting is stored in memory for all input signals. The COLOR settings allow you to adjust the picture's color temperature by changing the color level of the white color field. This setting is stored in memory for all input signals. This setting is stored in memory for the current input signal. Since the default setting is 9300K, the whites will change from a bluish hue to a reddish hue as the temperature is lowered to 6500K and 5000K. Then move the control button m/M to select R (red), G (green), or B (blue) and move </, to make the adjustment. Note Adjustment stops when either the horizontal or vertical size reaches its maximum or minimum value. If you fine tune the color temperature, the new color settings are stored in memory and recalled whenever you select USER. This monitor has the following three reset methods. Use the control button to select the adjustment item you want to reset, and press the RESET button. Adjust the selected item according to the following instructions. Note that the following items are not reset by this method: · The monitor is automatically demagnetized (degaussed) when the power is turned on. If a second degauss cycle is needed, allow a minimum interval of 20 minutes for the best result. Press and hold the RESET button for more than two seconds. Note that the following item is not reset by this method: · Then move the control button </, until the moire effect is at a minimum. * Moire is a type of natural interference which produces soft, wavy lines on your screen. It may appear due to interference between the pattern of the picture on the screen and the phosphor pitch pattern of the monitor. [. . . ] The energy requirements include a demand that the computer and/ or display, after a certain period of inactivity, shall reduce its power consumption to a lower level in one or more stages. the length of time to reactivate the computer shall be reasonable for the user. Labelled products must meet strict environmental demands, for example, in respect of the reduction of electric and magnetic fields, physical and visual ergonomics and good usability. Below you will find a brief summary of the environmental requirements met by this product. [. . . ]