User manual SONY CPD-E200/L

[. . . ] The model and serial numbers are located at the rear of the unit. record these numbers in the spaces provided below. Refer to them whenever you call upon your dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] Press the center of the control button to display the main MENU on your screen. See page 9 for more information on using the control button. Use the control button to select one of the following menus. If the signal matches one of this monitor's factory preset modes, the resolution is also displayed. You can use this to match the monitor's colors to a printed picture's colors. Press the center of the control button to display the main MENU on your screen. Brightness and contrast adjustments are made using a separate BRIGHTNESS/CONTRAST menu. These settings are stored in memory for all input signals. Highlight the desired menu by moving the control button towards the rear to go up (M), towards the front to go down (m), and left (<) or right (, ) to move sideways. Move the control button left (<) or right (, ) to make the adjustment. This setting is stored in memory for the current input signal. Press the center of the control button once to return to the main MENU, and twice to return to normal viewing. If no buttons are pressed, the menu closes automatically after about 30 seconds. Adjusting the size of the picture (SIZE) This setting is stored in memory for the current input signal. This setting is stored in memory for the current input signal. The COLOR settings allow you to adjust the picture's color temperature by changing the color level of the white color field. This setting is stored in memory for all input signals. Adjustment stops when either the horizontal or vertical size reaches its maximum or minimum value. Since the default setting is 9300K, the whites will change from a bluish hue to a reddish hue as the temperature is lowered to 5000K. All other settings are stored in memory for the current input signal. You can select your own color temperature between 9300K and 5000K. Then move the control button </, to make the adjustment. [. . . ] When the power is turned on, the monitor is automatically degaussed for five seconds. White does not look white Letters and lines show red or blue shadows at the edges Monitor buttons do not operate A hum is heard right after the power is turned on * If a second degauss cycle is needed, allow a minimum interval of 20 minutes for the best result. A humming noise may be heard, but this is not a malfunction. Displaying this monitor's name, serial number, and date of manufacture. [. . . ]