User manual SONY CPD-E240

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] 77 million colors In true color mode (24 bit), speed may be slower. To close the menu Press the MENU button once to return to the main menu, and twice to return to normal viewing. If no buttons are pressed, the menu closes automatically after about 30 seconds. You can make numerous adjustments to your monitor using the on-screen menu. See page 9 for more information on using the MENU button. You can use this to match the monitor's colors to a printed picture's colors. Use the +/- and ENTER buttons to select one of the following menus. See page 9 for more information on using the +/- and ENTER buttons. 0 LANGUAGE/INFORMATION (page 7, 15) Select the LANGUAGE/ INFORMATION menu to choose the on-screen menu's language and display this monitor's information box. If the signal matches one of this monitor's factory preset modes, the resolution is also displayed. These settings are stored in memory for all input signals. Note that the following items are not reset by this method: · The monitor is automatically demagnetized when the power is turned on. If a second degauss cycle is needed, allow a minimum interval of 20 minutes for the best result. With the exception of the USER settings in the COLOR menu, all of the adjustment data for all input signals is reset to the factory preset levels. Note The monitor's buttons will not operate for about 5 seconds when ALL is selected. Then press the +/- buttons until the moire effect is at a - minimum. Moire is a type of natural interference which produces soft, wavy lines on your screen. It may appear due to interference between the pattern of the picture on the screen and the phosphor pitch pattern of the monitor. When the monitor receives an input signal, it automatically matches the signal to one of the factory preset modes stored in the monitor's memory to provide a high quality picture at the center of the screen. (See Appendix for a list of the factory preset modes. ) For input signals that do not match one of the factory preset modes, the digital Multiscan technology of this monitor ensures that a clear picture appears on the screen for any timing in the monitor's frequency range (horizontal: 30 ­ 70 kHz, vertical: 48 ­ 120 Hz) . If the picture is adjusted, the adjustment data is stored as a user mode and automatically recalled whenever the same input signal is received. [. . . ] Since all methods of conventional electricity generation have a negative effect on the environment (acidic and climateinfluencing emissions, radioactive waste, etc. Electronics equipment in offices consume an enormous amount of energy since they are often left running continuously. This product meets the requirements for the TCO'95 scheme which provides for international and environmental labelling of personal computers. the labelling scheme was developed as a joint effort by the TCO (The Swedish Confederation of Professional Employees) , Naturskyddsforeningen (The Swedish Society for Nature Conservation) and NUTEK (The National Board for Industrial and Technical Development in Sweden). [. . . ]