User manual SONY CPD-E240-B

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] It may not work properly if the background color is dark or if the input picture does not fill the screen to the edges (such as an MSDOS prompt). The displayed image moves for a few seconds while this function is performed. To rotate the picture expand or contract the picture sides shift the picture sides to the left or right adjust the picture width at the top of the screen shift the picture to the left or right at the top of the screen For more information about using the RESET mode, see "Resetting the adjustments (RESET)" on page 18. The CONVERGENCE settings allow you to adjust the quality of the picture by controlling the convergence. The convergence refers to the alignment of the red, green, and blue color signals. If you see red or blue shadows around letters or lines, adjust the convergence. These settings are stored in memory for all input signals. The SCREEN settings allow you to degauss (demagnetize) the monitor manually and adjust the picture quality by controlling the moire and landing. If the color is not uniform or picture is fuzzy, degauss the monitor (DEGAUSS). The monitor is automatically demagnetized (degaussed) when the power is turned on. the screen is degaussed for about 2 seconds. Note that the following items are not reset by this method: · If no signal is input to the monitor from your computer, the monitor will automatically reduce power consumption as shown below. power mode Power consumption* 135 W (CPD-G520) 130 W (CPD-E240-B) !(power) indicator green orange off Note The RESET function does not function when is set to ON. Figures reflect power consumption when no USB compatible peripherals are connected to the monitor. ** When your computer enters power saving mode, the input signal is cut and NO SIGNAL appears on the screen before the monitor enters active off mode. After a few seconds, the monitor enters power saving mode. Before contacting technical support, refer to this section. This indicates that the input signal is not supported by the monitor's specifications. If thin lines appear on your screen (damper wires) The visible lines on your screen especially when the background screen color is light (usually white), are normal for the Trinitron monitor. These are shadows from the damper wires used to stabilize the aperture grille. The aperture grille is the essential element that makes a Trinitron picture tube unique by allowing more light to reach the screen, resulting in a brighter, more detailed picture. [. . . ] If the input signal does not match one of the factory preset modes above, the Generalized Timing Formula feature of this monitor will automatically provide an optimal image for the screen as long as the signal is GTF compliant. The environmental demands impose restrictions on the presence and use of heavy metals, brominated and chlorinated flame retardants, CFCs (freons) and chlorinated solvents, among other things. The product must be prepared for recycling and the manufacturer is obliged to have an environmental policy which must be adhered to in each country where the company implements its operational policy. The energy requirements include a demand that the computer and/ or display, after a certain period of inactivity, shall reduce its power consumption to a lower level in one or more stages. [. . . ]