User manual SONY CPD-E400E

[. . . ] The model and serial numbers are located at the rear of the unit. record these numbers in the spaces provided below. Refer to them whenever you call upon your dealer regarding this product. If shipped to USA/Canada, install only a UL LISTED/CSA LABELLED power supply cord meeting the following specifications: SPECIFICATIONS Plug Type Nema-Plug 5-15p Cord Type SVT or SJT, minimum 3 × 18 AWG Length Maximum 15 feet Rating Minimum 7 A, 125 V To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] 2, 6500K), you must set your computer to the sRGB profile. When you set sRGB to "ON" the brightness ( ) and contrast (6) are automatically set to "31" and "85" respectively. If you change the brightness ( ) and contrast (6), sRGB setting is changed to "OFF. " For information on how to change the brightness ( ) and contrast (6) , see page 10. Note Your computer and other connected products (such as a printer), must be sRGB compliant. The CONV settings allow you to adjust the quality of the picture by controlling the convergence. The convergence refers to the alignment of the red, green, and blue color signals. If you see red or blue shadows around letters or lines, adjust the convergence. These settings are stored in memory for all input signals. You can manually degauss (demagnetize) the monitor, adjust the moire cancellation level, change the menu position, and lock the controls. Adjust the selected item according to the following instructions. The monitor is automatically demagnetized (degaussed) when the power is turned on. If a second degauss cycle is needed, allow a minimum interval of 20 minutes for the best result. Then move the control button </, until the moire effect is at a minimum. * Moire is a type of natural interference which produces soft, wavy lines on your screen. It may appear due to interference between the pattern of the picture on the screen and the phosphor pitch pattern of the monitor. To protect adjustment data by locking the controls, first move the control button m/M to select (CONTROL LOCK). If any other items are selected, the mark appears on the screen. Note The RESET button does not function when set to ON. When the monitor receives an input signal, it automatically matches the signal to one of the factory preset modes stored in the monitor's memory to provide a high quality picture at the center of the screen. (See Appendix for a list of the factory preset modes. ) For input signals that do not match one of the factory preset modes, the digital Multiscan technology of this monitor ensures that a clear picture appears on the screen for any timing in the monitor's frequency range (horizontal: 30 ­ 96 kHz, vertical: 48 ­ 120 Hz). [. . . ] The product must be prepared for recycling and the manufacturer is obliged to have an environmental policy which must be adhered to in each country where the company implements its operational policy. The energy requirements include a demand that the computer and/ or display, after a certain period of inactivity, shall reduce its power consumption to a lower level in one or more stages. the length of time to reactivate the computer shall be reasonable for the user. Labelled products must meet strict environmental demands, for example, in respect of the reduction of electric and magnetic fields, physical and visual ergonomics and good usability. [. . . ]