User manual SONY CPD-E430

[. . . ] The model and serial numbers are located at the rear of the unit. record these numbers in the spaces provided below. Refer to them whenever you call upon your dealer regarding this product. If shipped to USA/Canada, install only a UL LISTED/CSA LABELLED power supply cord meeting the following specifications: SPECIFICATIONS Plug Type Nema-Plug 5-15p Cord Type SVT or SJT, minimum 3 × 18 AWG Length Maximum 15 feet Rating Minimum 7 A, 125 V To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] Try plugging the monitor into a different AC outlet, preferably on a different circuit. Try turning the monitor 90° to the left or right. Check your graphics board manual for the proper monitor setting. Confirm that the graphics mode and the frequency of the input signal are supported by this monitor (see "Preset mode timing table" on page i). Even if the frequency is within the proper range, some graphics board may have a sync pulse that is too narrow for the monitor to sync correctly. If ACTIVATE BY COMPUTER appears on the screen, try pressing any key on the computer or moving the mouse, and confirm that your computer's graphic board is completely seated in the correct bus slot. Check that all plugs are firmly seated in their sockets. Note that with some input signals and/ or graphics board the periphery of the screen is not fully utilized. Just after turning on the power switch, the size/center may take a while to adjust properly. If you are replacing an old monitor with this monitor, reconnect the old monitor. Then adjust the computer's graphic board so that the horizontal frequency is between 30 ­ 96 kHz, and the vertical frequency is between 48 ­ 170 Hz. * If you place equipment that generates a magnetic field, such as a speaker, near the monitor, or if you change the direction the monitor faces, color may lose uniformity. X White does not look white To display this monitor's name, serial number, and date of manufacture. While the monitor is receiving a video signal, press and hold the MENU button for more than 5 seconds to display this monitor's information box. 0" viewing image Resolution (H:Horizontal, V:Vertical) Maximum: H: 1920 dots, V: 1440 lines Recommended: H: 1280 dots, V: 1024 lines Input signal levels Video signal: Analog RGB: 0. (damper wires) These lines do not indicate a malfunction; they are a normal effect of the Trinitron picture tube with this monitor. These are shadows from the damper wires used to stabilize the aperture grille. The aperture grille is the essential element that makes a Trinitron picture tube unique by allowing more light to reach the screen, resulting in a brighter, more detailed picture. This monitor is equipped with a self-diagnosis function. If there is a problem with your monitor or computer, the screen will go blank and the !(power) indicator will either light up green or flash orange. Try pressing any key on the keyboard or moving the mouse. [. . . ] CFCs (freons) The relevant TCO'99 requirement states that neither CFCs nor HCFCs may be used during the manufacture and assembly of the product. CFCs (freons) are sometimes used for washing printed circuit boards. CFCs break down ozone and thereby damage the ozone layer in the stratosphere, causing increased reception on earth of ultraviolet light with e. Lead** Lead can be found in picture tubes, display screens, solders and capacitors. [. . . ]