User manual SONY CPD-E530

[. . . ] Dangerously high voltages are present inside the set. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Before using this monitor, please make sure that the following items are included in your package: Multiscan 100sf/200sf monitor (1), power cord (1), HD15 (Female) - HD15 (Male without the No. 9 pin) adapter (1), warranty card (1) and this operating instruction manual (1). This monitor will sync with any IBM or compatible system equipped with VGA or greater graphics capability. Although this monitor will sync to other platforms running at horizontal frequencies between 30 and 70 kHz (Multiscan 100sf), 30 and 80kHz (Multiscan 200sf), including Macintosh and Power Macintosh system, a cable adapter is required. Please consult your dealer for advice on which adapter is suitable for your needs. Step 1: With the computer switched off, attach the video signal cable to the video output. The Multiscan 100sf/200sf has factory preset modes for the 7 most popular industry standards for true "plug and play" capability. For less common modes, the Multiscan 100sf/200sf 's Digital Multiscan Technology will perform all of the complex adjustments necessary to ensure a high quality picture for any timing between 30 and 70 kHz (Multiscan 100sf ), 30 and 80 kHz (Multiscan 200sf ). For the customers using IBM PC or IBM compatible system which is not compatible with DDC2AB and DDC2B+ This monitor uses a No. 9 pin in the video signal connector for DDC2AB and DDC2B+ compatibility. Some PC systems which are not compatible with either DDC2AB or DDC2B+ may not accept the No. To reset all adjustment data at once (for the received signal) Press the RESET button with something like a pen for 1 second when no OSD is shown. The "COLOR TEMPERATURE" OSD automatically disappears 10 seconds after you release the buttons. When using a video mode that is not one of the factory preset modes, some fine tuning may be required to optimize the display to your preferences. Simply adjust the monitor according to the preceding adjustment instructions. This monitor complies with the DDCTM1, DDC2B, DDC2AB and DDC2B+ which are the Display Data Channel (DDC) standards of VESA. When a DDC1 host system is connected, the monitor synchronizes with the V. cLK in accordance with the VESA standards and outputs the EDID (Extended Display Identification Data) to the data line. When a DDC2B, DDC2AB or DDC2B+ host system is connected, the monitor automatically switches to each communication. This monitor meets the power saving guidelines set by the International ENERGY STAR Program as well as the more stringent TCO92 803299 (NUTEK) guidelines. It is capable of reduced power consumption when used with a computer equipped with Display Power Management Signaling (DPMS). By sensing the absence of the sync signal coming from the computer, it will reduce the power consumption as follows: CAUTION: The Power Saving function will automatically put the monitor into Active-off state if the power switch is turned on without any video signal input. [. . . ] -- Check that the video card is seated completely in a proper bus slot. -- Check that the video sync signal is within that specified for the monitor. -- If using a Mac system, check that a proper HD15 - D15 adapter is provided to work correctly with your Mac. -- The monitor has a self-diagnose function. [. . . ]